Idiomas disponibles
Idiomas disponibles
In case a screw gets stuck during tightening:
Unfasten the screw and try to move it in the right position.
Do not tighten the screw with brute force!
13
OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
13.1 Operation instructions
Perform all machine settings with the machine being
disconnected from the power supply!
• Place the machine next to the woodworking machine in a way that it will not
interfere with your work!
• Start to work with the woodworking machine only until the dust collector has
reached full speed!
13.2 Connection of dust collector to machine
Ensure dust collector tubes to be composed of hardly inflammable material and antistatic.
The total distance between dust collector hood of the ABS and machine dust collector hood shall
not exceed 10 meters.
13.3 Switch unit
On-off-switch:
Press green button (I): turn on
Press red button (0): turn off
14
MAINTENANCE
Don't clean or do maintenance on the machine while it is still connected to the
power supply:
Damages to machine and injuries might occur due to unintended switching on
of the machine!
Therefore: Switch the machine off and disconnect it from the power supply be-
fore any maintenance works or cleaning is carried out
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all con-
necting parts (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the machine.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
Store the machine in a closed, dry location.
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a pre-
requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
HOLZMANN MASCHINEN GmbH
WARNING
www.holzmann-maschinen.at
NOTE
NOTE
ATTENTION
NOTE
OPERATION
22
ABS 2200FLEX
