LED indicator / beeper
► 1. LED indicator
LED indicator / beeper on the tool shows the following functions.
Alarm No.
E0
Battery installation
error
E1
Auto-stop
E2
Anti-reset of
controller
E3
Auto-stop with low
remaining battery
capacity
E4
Overload protection
E5
Overheat protection
E6
Motor lock
E7
Motor failure
E8
Switch failure
E9
Alarm for a long
period of use
1
Function
Status of the tool
If the battery car-
tridge is installed
with the switch
trigger pulled, the
tool stops to avoid
unintentional start.
The battery power
became low and it is
time to replace the
battery cartridge.
The battery voltage
dropped abnor-
mally for some
reason, and the tool
stopped.
The battery power is
almost used up and
the tool stopped.
The tool was over-
loaded and stopped.
Tool's controller
heated up abnor-
mally and the tool
stopped.
The motor has been
locked. At this time,
the tool does not
work.
The tool detected a
motor failure. At this
time, tool does not
work.
The tool detected a
switch failure.
The tool has been
turned on for a long
time (Approx. 3
minutes).
Status of the LED indicator/beeper
LED indicator
Blinks in red and
green alternatively.
Blinks in red and
green alternatively.
Blinks in red and
green alternatively.
Lights up in red.
Blinks in red and
green alternatively.
Blinks in red quickly.
Blinks in red and
green alternatively.
Blinks in red and
green alternatively.
Blinks in red and
green alternatively.
Blinks in red and
green alternatively.
11 ENGLISH
Action to be taken
Beeper
A series of long
Install the battery
beeps
cartridge with
the switch trigger
released.
A series of long
Replace the battery
beeps
with fully charged
one.
A series of long
Replace the battery
beeps
with fully charged
one.
A long beep
Replace the battery
with fully charged
one.
A series of long
Remove the cause
beeps
of overload, and
then restart the tool.
Ask your local
Makita Service
Center for repair.
A series of long
Remove the battery
beeps
cartridge immedi-
ately and cool the
tool down.
A series of long
Release the switch
beeps
trigger and pull it
again.
A series of long
Ask your local
beeps
Makita Service
Center for repair.
A series of long
Ask your local
beeps
Makita Service
Center for repair.
A long beep
Release the switch
trigger and pull it
again.