Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Battery remaining capacity indicator
(only for models with Battery BL3622A)
Battery BL3622A is equipped with the battery remaining
capacity indicator.
1
2
011715
Press the CHECK button to indicate the battery
remaining capacity. The indicator lamps will then light for
approx. three seconds.
Indicator lamps
Lighted
Off
Blinking
E
011713
When only the lowermost indicator lamp (next to
•
the "E") blinks, or when none of the indicator lamps
light, the battery capacity has run out, so the tool
does not operate. In these cases, charge the
battery or replace the empty battery with a fully
charged one.
When two or more indicator lamps do not light
•
even after charging is complete, the battery has
reached the end of its service life.
When the upper two and lower two indicator lamps
•
light
alternately,
malfunctioned.
authorized service center.
NOTE:
The indicated capacity may be lower than the
•
actual level during use or immediately after using
the tool.
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
1. Indicator lamps
2. CHECK button
Remaining capacity
70% to 100%
F
45% to 70%
20% to 45%
0% to 20%
Charge the battery.
The battery may have
malfunctioned.
the
battery
may
Contact
your
local
ASSEMBLY
WARNING:
Always be sure that the tool is switched off and
•
battery cartridge is removed before carrying
out any work on the tool. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Installing the grip
3
2
012763
Securely fit the barrier and grip onto the shaft pipe with
two screws and clamps.
Make sure that the spacer on the shaft pipe is located
between the grip and the hanger. Do not remove or
shrink the spacer.
CAUTION:
Never install the grip on the label or joint.
•
NOTE:
In some countries, the barrier and spacer are not
•
provided with the tool. In that case, align the
handle to further side of the line which is indicated
by the arrow marks.
Mounting the attachment
have
Makita
1
1
4
012660
To mount the attachment to a power unit:
1.
Make sure that the lock lever is not tightened.
2.
Align the pin with the arrow mark.
3.
Insert the shaft into the drive shaft of the power
unit until the release button pops up.
4.
Tighten the lock lever firmly as shown.
8
1. Grip
2. Clamp
3. Barrier
4. Spacer
1
4
1. Lock lever
4
2. Pin
3
3. Arrow mark
4. Release button
3
2
2
Tabla de contenido
