Idiomas disponibles
Idiomas disponibles
6. INITIAL USE
Before you use the EM 59 Heat for the first time, let it charge for a mini-
mum of 4 hours. Proceed as follows.
1. Connect the USB charging cable to a mains adapter (max. output 5V/2A)
and the EM59 Heat
2. Then insert the mains adapter into a suitable socket.
3. Alternatively, you can charge the device using your
computer/laptop. To do so, connect the device to a
USB port on your PC/laptop via the USB charging
cable. You cannot use the device while it is being
charged.
4. Turn the belt clip if required.
5. Guide the connection cable plugs into the socket on
the bottom of the device (Fig. 3).
6. Do not pull, twist or kink the cables (Fig. 4).
7. Now attach the supplied gel pads to the electrodes.
Remove one of the protective films carefully (Fig. 5).
Carefully attach the gel pad to the electrodes and care-
fully detach the protective film (Fig. 6). Ensure that the
edge of the gel pad does not protrude over the elec-
trode. Applying gel pads slightly askew will not affect the
function.
WARNING!
Remove the protective film slowly and carefully. Make
sure that the self-adhesive gel fpad is not damaged, as
damage or unevenness on the gel pad may cause skin
irritation.
7. USE
Notes on use
• The device switches itself off automatically if it is not used for one
minute (automatic switch-off). When the unit is switched on again,
the LCD screen displays the menu selection and the most recently
used menu flashes.
• A brief acoustic signal is output when a valid button is pressed. Two
brief acoustic signals are output when an invalid button is pressed.
• You can pause the stimulation at any time by briefly pressing the ON/
OFF button
button
Starting use
Step 1: Look for a suitable program from the program tables (see section
"7. Program overview").
Fig. 3
Step 2: Place the electrodes on the desired area for treatment (for posi-
tioning suggestions see section "7.4 Information regarding the positioning
of electrodes") and connect them to the device.
Step 3: Press the ON/OFF button
Step 4: Press the MENU button to navigate through the
Fig. 4
/
your selection.
Step 5: Use the / setting buttons to select the program number you
want and press the ENTER button to confirm your selection. At the start
of the stimulation treatment, the impulse intensity of
Fig. 5
to 00 by default. No impulses are sent to the electrodes yet.
Step 6: Use the left and right / setting buttons for
select the impulse intensity you want. The indicator for impulse intensity
in the display changes accordingly. If the program is in a pause phase, the
intensity cannot be increased.
Step 7: You can activate the heat function using the heat function button.
Fig. 6
The first press of the button activates the low heat level, the second but-
ton press activates the high heat level, and the third button press deacti-
vates the heat function.
27
. To continue the stimulation, briefly press the ON/OFF
again and set the desired impulse intensity again.
to switch on the device.
menus and press the ENTER button to confirm
/
and
is set
and
to
