Metabo LF 850 S Manual Original página 11

Lay the paint remover on its side.
Press the locking button (2) up to the stop and keep
pressed.
Simultaneously turn the cutter head using the
hexagonal wrench (9-a) (any direction). Turn until
the pressed locking button noticeably engages and
the cutter head is locked.
7.3 Setting the axial cutting depth
Danger of injury from the sharp edges of the
reversible blades. Set the axial cutting depth
only when the cutter head is idle! Switch off paint
remover and pull the mains plug from the socket!
Lock the cutter head and keep the locking button
pressed.
Set the desired cutting depth by turning the setting
screw using a hexagonal wrench (9-a).
Possible cutting depths: 0-0.3 mm
Start with a small cutting depth and increase it
gradually until you have reached the optimum
setting for the workpiece to be processed.
Do not leave the hexagonal wrench in
place!
7.4 Attaching / Removing the extraction
connection piece
Use a Metabo all-purpose vacuum cleaner for dust
extraction purposes.
Attachment
Push the extraction connection piece (7) until it
engages into the extraction nozzle (6).
Now the desired extraction unit can be connected to
the extraction connection piece with the pipe
diameter 35 mm.
Removal
Press the lip and simultaneously remove the
extraction connection piece (7) from the extraction
nozzle (6).
8. Tips and Tricks
8.1 Guiding the paint remover
Always use two hands to guide the paint remover
backwards where possible over the surface of the
workpiece being processed. When holding the
paint remover down, ensure that the low pressure
exerted is distributed evenly over the area of the
planing base.
8.2 Presenting the tool to the edge of a workpiece
A
See diagram A: Hold the paint remover parallel with
the surface of the workpiece. When presenting the
tool, ensure that the planing base is in contact with
the largest possible area of the surface (10).
8.3 Operation
B C
See diagram B: Guide the paint remover in such a
way that the planing base (10) is always positioned
on the surface that has not yet been processed. If
you proceed as shown, a narrow section is left over.
See figure C: You can remove this section by setting
the cutting depth to 0 mm (see section 7.3) and now
always guide the planing base (10) over the
processed surface.
8.4 Smoothing
Reduce the cutting depth to achieve a smooth
surface finish.
9. Maintenance
Danger of injury from the sharp edges of the
reversible blades. Effect maintenance work
only when the cutter head is idle! Switch off paint
remover and pull the mains plug from the socket!
Always wear personal protective equipment,
safety goggles, ear protectors, protective
gloves and heavy-duty footwear during work and for
all setting, conversion and maintenance tasks!
ENGLISH en
11