Initial Operation; Assembly Of The Additional Handle; Operating Mode Selection - Metabo KHE 2245 Manual Original

specially designed to filter out microscopic
particles.
This also applies to dust from other materials, such
as some timber types (like oak or beech dust),
metals, asbestos. Other known diseases are e.g.
allergic reactions, respiratory diseases. Do not let
dust enter the body.
Observe the relevant guidelines and national
regulations for your material, staff, application and
place of application (e.g. occupational health and
safety regulations, disposal).
Collect the particles generated at the source, avoid
deposits in the surrounding area.
Use suitable accessories for special work. In this
way, fewer particles enter the environment in an
uncontrolled manner.
Use a suitable extraction unit.
Reduce dust exposure with the following measures:
- do not direct the escaping particles and the
exhaust air stream towards yourself or nearby
persons or towards dust deposits,
- use an extraction unit and/or an air purifier,
- ensure good ventilation of the workplace and keep
it clean using a vacuum cleaner. Sweeping or
blowing stirs up dust.
- Vacuum or wash protective clothing. Do not blow,
beat or brush protective gear.
5. Overview
See page 2.
1 SDS chuck
2 Tool lock
3 Chuck lock
4 Keyless chuck *
5 Sleeve keyless chuck *
6 Spindle *
7 Additional handle
8 Depth stop
9 Lock
10 Switch button (for changing the operating
mode)
11 Rotation selector switch
12 Lock button
13 Trigger switch
* depending on equipment/not in scope of delivery

6. Initial Operation

Before commissioning, check that the rated
mains voltage and mains frequency stated on
the type plate match your power supply.
Always install an RCD with a maximum trip
current of 30 mA upstream.
6.1

Assembly of the additional handle

For safety reasons, always use the additional
handle supplied.
Open the clamping ring by turning the side handle
(7) anti-clockwise. Push the additional handle onto
the collar of the machine. Insert the depth stop (8).
Securely tighten the additional handle at the angle
required for the application.
7. Use
7.1 Depth Stop Setting
Loosen the additional handle (7). Set the depth stop
(8) to the desired drilling depth and retighten
additional handle (7).
7.2 Switching On and Off
Press the trigger switch (13) to switch on the
machine.
The speed can be changed using the trigger switch.
For continuous operation, the trigger button can be
locked using the lock button (12) . Press the trigger
switch again to stop the machine.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands using the handles provided, stand
securely and concentrate.
7.3

Operating mode selection

Press the lock (9) and turn the thumbwheel (10).
Hammer drilling
(Set only when using the hammer chuck (1) )
Chiselling
(Set only when using the hammer chuck (1) )
Setting chisel position
Turn the chisel in the desired position. Then
select "Chiselling" to secure the chisel and
prevent it from twisting.
Drilling
When a chisel is fitted, only operate the
machine in the chiselling operating mode
Avoid levering with the machine when a chisel
is fitted.
7.4 Selection of direction of rotation
Only activate the rotation selector switch (11)
when the motor has completely stopped.
Select direction of rotation:
R = clockwise rotation (for drilling, hammer
drilling, chiselling, drive in screws)
L = anti-clockwise rotation (for the removal of
screws)
7.5 Changing the chuck (KHE .... Q)
Ensure a clean spindle (6) when changing the
chuck. Apply a light coating of grease to the
spindle. (Special grease: Order No.: 6.31800)
Only attach the Metabo chuck provided.
Removing the chuck:
See page 2, fig. C.
ENGLISH en
.
9