Troubleshooting - Dolmar TM-102.16 Manual De Instrucciones

TROUBLESHOOTING

7. TROUBLESHOOTING
PROBLEM LIKELY CAUSE
1. With the key at The protection of the electronic card has
«ON» the dashboard cut in due to:
remains off with no
audible signal. – badly connected battery
– battery terminals crossed
– completely flat battery or eroded bat-
tery plates
– fuse blown
2. With the key at The protection of the electronic card has
«ON» the dashboard cut in due to:
remains off, but there
is an audible signal. – electronic card wet
3. With the key on – insufficiently charged battery
«START» the dash- – battery charger fuse blown
board comes on but
the starter motor does
not runa
4. With the key on – insufficiently charged battery
«START» the starter – faulty fuel supply
motor runs but the
engine does not start
– faulty ignition
5. Starting is difficult – fault in carburation
or the engine runs
erratically
6. Weak engine per- – forward speed too high in relation to
formance during cut- cutting height (☛ 5.4.5)
ting
SOLUTION
Put the key in the «OFF» position and
look for the cause of the problem:
– check connections (☛ 3.4)
– check connections (☛ 3.4)
– recharge battery (☛ 6.2.5)
– replace fuse (10 A) (☛ 6.4.4)
Put the key in the «OFF» position and
look for the cause of the problem:
– dry using tepid air
– recharge the battery (☛ 6.2.5)
– replace fuse (25 A) (☛ 6.4.4)
– recharge the battery (☛ 6.2.5)
– check the level in the tank (☛ 5.3.3)
– open the fuel stopcock (
(☛ 5.4.1)
– check fuel filter
– check that spark plug caps are firmly
fitted
– check that the electrodes are clean
and have the correct gap
– clean or replace the air filter
– flush out the float chamber
– empty fuel tank and refill with fresh
fuel
– check and, if necessary, replace fuel
filter
– reduce the forward speed and/or raise
the cutting deck
43
EN
➤
if fitted)