Idiomas disponibles
Idiomas disponibles
ENTRY OF THE LOCK RELEASE CODES
The Call Module makes it possible to insert up to 240
lock release codes that are completely independent
of the names, for general use.
These codes must be numeric only and each
consist of a number of digits that can be selected as
required (between 1 and 8). Therefore the permitted
range.is.1.to.99999999.
METHODS OF INSERTION
The lock release codes can be inserted:
1) Using the Ref. 1038/56 Programming Terminal
connected locally or at any other point of the
installation.
2) Locally from keyboard. In this case, the password
for programming of the names and lock release
codes must be known (this is DIFFERENT from
the configuration access password).
INSERTION USING THE 1038/56 TERMINAL
After establishing a logical connection with
the call Module concerned (see description in
'PROGRAMMING WITH THE 1038/56 TERMINAL),
move to the following page:
<Names>
<Lock release>
<Program>
<Cancel><Exit>
− Select <Lock release> and press ↵.
The first 3 lock release codes will be displayed:
Lockrel001:00000000
Lockrel002:00000000
Lockrel003:00000000
<P><S><OK><ESC>
− Enter the code(s) required and then, using the
← and.→ keys move to the <OK> command and
press.↵.
. WARNING: THE 3 CODES ARE EFFECTIVELY
SAVED
IN
THE
FOLLOWING
CONFIRMATION
<OK> COMMAND. Saving is confirmed visibly.
− To access the three subsequent codes select
the <S> command and press ↵. Alternatively, to
access the three previous codes select <P> and
press.↵..
− Once the codes have been programmed, select
<EXIT> and press ↵ and then the ← key to move
DS1038-030
CALL
MODULE
WITH
to the previous page, select <Exit> and press ↵.
− Disconnect the programming cable and switch
off the terminal pressing the 'OFF' key for at
least 3 seconds or if the same lock release
codes have to be programmed on another call
module connected in the system repeat the steps
described above.
NOTE: to delete a lock release code, reprogram this
to '00000000'.
ENTRY VIA KEYBOARD
− Enter '00' followed by the 4-digit password (for
programming of the names and lock release
codes) and by the 'Call' key. If the password is
incorrect, the following message is displayed:
After the third unsuccessful attempt, entry of
the password is blocked for a period of time
that depends on the number of unsuccessful
attempts:
No. unsuccessful
attempts
.
.
.
.
.
.
.
255
Once the password has been entered correctly
the display will show:
<Names>
<Lock release><Esc>
− Select <Lock release> and press 'Call'. The first
page with the first two lock release codes will be
displayed:
ONLY
THE
Lockrel001:00000000
Lockrel002:00000000
− Enter the lock release code and then confirm with
the 'Call' key.
− Use the Arrows to check the codes already
inserted and to move to the new codes.
INCORRECT
PASSWORD
Wait time before
new password insertion
1.
.
3.
4.
1.minute
5.
.minutes
6.
3.minutes
•
•
252 minutes (above 4 hours)
-
-
-
•
•
9
