Idiomas disponibles
Idiomas disponibles
beeps, etc.) can be adjusted to 3 possible
levels: Minimum (Min), Medium (Med),
Maximum (Max).
9) Code associated to Key T1
In the case of combination with a Ref.
1148/11 or -/12 module, the code associated
to pressing of the first key must be specified.
If this key is to send a call to a specific
Main Entrance Switchboard - both during
the day and night but not when off – program
the indoor set code of the Main Entrance
Switchboard.
If the key is to send a call to any switchboard
present that is in 'day A' condition, program
'0000'.
Programmable codes are between '0000'
and '9999'.
10) Code associated to Key T2
This is the code associated to the second
key of any Ref. 1148/12 module.
Programmable codes range from '0000' to
'9999'.
11) Saving of the Configuration Access
Password and (automatically) of the lock
release code programming password.
The password must be numeric ONLY and
must consists of 4 digits.
The password programmed in this way can
then be used to access module configuration
without having to open the Sinthesi S2
frame.
Programming of the configuration access
password automatically enables a second
password that can be used to program
name and lock release codes. This second
password is derived from the first with an
increment of 1. If, for example, '1234' has
been programmed, the name and lock release
code programming password will be '1235'.
The installation technician can therefore
reveal to others (system administrator, porter
etc.) ONLY the name and lock release code
programming password avoiding any risk of
access also to configuration parameters.
The values that can be programmed range
from.0001.to.9998.
PROGRAMMING
USING
TERMINAL
Programming using the terminal must be carried out
with the system on.
− Switch on the terminal holding down the 'ON' key
for at least 3 seconds.
6
THE
Ref.
1038/56
− Insert the programming cable in the specific outlet
(2) or - alternatively – on another call Module or
Main Entrance Switchboard. The terminal will be
connected automatically to the data line and the
following message will be shown on the display
for 3 seconds:
Programming
and then:
Find:
<Serial Number>
<Type>
<Acquisition>
− Select the <Serial Number> option.
The following message is displayed:
Serial Number:
Enter the serial number of the Call Module (given
on the rear label (10) at the S/N item), and press
↵ key. The following message is displayed:
REP
SN:uvwxyz
- - - - - - - - - - - - - - -
Road . . . . . . . . . . . . .
At this point, the terminal is connected logically
with the Call Module with Repertory (REP) with
the selected serial number ('uvwxyz'). To indicate
that the module is in Maintenance status, the
display of the module will show:
MAINTENANCE
Please wait
NOTE: t he module permits management of the
electric lock also in 'Maintenance' status,
both following entry of a lock release code
and activation of the main entrance button
or of the postman key contact.
− At this point, the following can be programmed:
the description of the installation site, the
11 configuration parameters and the operating
language divided into four pages:
(Page 1: Device recognized (REP) and its Serial
Number, both non-modifiable; Description of the
installation site)
000000
DS1038-030
