Cameo PIXBAR G2 SMD Manual De Usuario página 18

Idiomas disponibles

This will take you to the submenu for configuring the submenu items (see table). The settings for

each loop are made separately and are retained even after restarting the device.

SLAVE MODE

Standard slave operation: Starting from the main display, press MENU to enter the main menu.

Using the UP and DOWN buttons, you now select the menu item Slave confirm with ENTER,

select the Slave Group 0 and confirm again with ENTER. Connect the slave and master units

(same model, same software version) using a DMX cable or via W-DMX™ and activate one of the

stand-alone operating modes (Direct LED, Play Scene/Loop) in the master unit. The slave unit will

now follow the master unit.

Extended slave operation: If you want to control the slave units by one of the stand-alone

modes Auto Program or Play Loop in master / slave operation, the control signal can be played

back with a time delay of up to 24 steps, the delay is set in the Stand Alone menu Master/Alo-

ne in the master unit, the delay factor in the slave menu of the corresponding fixture (Group). This

is a simple way to create a running light effect with a large number of spotlights that are all the

same model and have the same software version. This is otherwise only possible using a suitable

DMX controller and time-consuming programming. Connect the slave and master units (same

model, same software version) using a DMX cable or via W-DMX™.

Step selection

Setting the step duration for

the selected step

Setting the fade time for the

selected step

Selection of the scene or

blackout for the selected step

Select scene or blackout or

skip selected step

Clpbsmdipg2