Idiomas disponibles
Idiomas disponibles
SETTING DMX START ADDRESS (DMX address)
Starting from the main display, press MENU to enter the main menu. Now use UP and DOWN to
select the menu item DMX Address and confirm with ENTER. Using the UP and DOWN buttons,
configure the desired DMX start address and press ENTER to confirm (highest value dependent
upon activated DMX mode).
CONFIGURING DMX MODE (DMX Mode)
Starting from the main display, press MENU to enter the main menu. Now use UP and DOWN to
select the menu item DMX Mode and confirm with ENTER. Now select the desired DMX mode
using UP and DOWN and confirm the selection with ENTER. DMX operating modes with DMX delay
channel and group selection (Group 0 - 24) are marked with "D". Tables with the channel assign-
ments can be found in these instructions under DMX CONTROL.
DMX modes with DMX delay channel
The DMX Delay function is a simple way to create a running light effect with a large number of
spotlights that are all the same model and that are all running the same software version. This
is otherwise only achievable with a suitable DMX controller and time-consuming programming.
All the spotlights used (same models, same software version) are set to the same DMX operating
mode with DMX delay channel and controlled via the same DMX start address.
Setting the DMX delay: Select one of the DMX operating modes with DMX delay channel and con-
firm the selection (in the example D7 CH Direct). Assign the spotlights to one of up to 24 groups
as required (plus group 0), whereby several spotlights can also be assigned to one group. The
group number is also the factor by which the set delay time set in the DMX controller is multiplied.
Confirm each entry by pressing ENTER.
14
