Foppapedretti TicToc Manual De Instrucciones página 28

• ENGLISH •
ASSEMBLY
FITTING THE HOOD
Removing the hood (fig. 18, 19): fasten the hood support to both sides of the chassis.
Fitting the hood (fig. 20): pull and release the hood support from both sides of the chassis.
FITTING THE PUSHCHAIR RAINCOVER (fig. 21)
Fit the raincover over the hood.
Fasten the edges at the back of the raincover using the Velcro tabs.
Fasten the front of the raincover to the chassis of the pushchair using the press studs.
STORAGE BASKET (fig. 22)
Disassembly: The basket is fixed to the lower part of the frame with a zip: to remove it, unzip on both sides. The basket
should be emptied before folding the pushchair.
Assembly: repeat this process in reverse order.
USE
HOW TO OPEN THE PUSHCHAIR (fig. 23, 24, 25, 26, 27, 28)
Press the folding lock button "A".
Press the button "b" (1) and extend the handlebar until its opens completely (2).
Lift the handlebar until the chassis opens completely. A click will indicate that is has been fastened (fig 24).
WARNING: Before use, pull the seat upwards to check that it has been fastened correctly to the chassis.
Lift up the seat until you hear a CLICK (fig. 25).
Lift up the lever "b" and at the same time push the backrest upwards until you hear a CLICK, this will indicate that it is in
place correctly.
Lift up the protective armrest. A click will indicate that it is locked (fig. 27).
WARNING: Before use, pull the seat upwards to check that it has been fastened correctly to the chassis. Before using the
stroller, make sure it is opened properly and the mechanisms are properly locked (fig. 28).
IMPORTANT: when the stroller is in use, the armrest must always be used and locked in position; if the armrest is removed,
check that the armrest supports are lifted up and locked properly in the vertical position (fig. 29).
TO ADJUST THE HANDLEBAR (fig. 30)
Press the button "b" and extend the handlebar to the desired position. Make sure that the handlebar is properly locked
in the new position.
TO REGULATE THE BACKREST (fig. 31)
Lift the regulating lever "a" located behind the backrest and recline the backrest to the required position. Release the lever
and make sure the backrest is secured in position.
WARNING (fig. 32): For babies under 6 months of age, the backrest must only be in the fully reclined, horizontal position
at all times.
TO DIRECT THE FRONT WHEEL (fig. 33)
Push the stroller forwards to direct the front wheels longitudinally.
Move the lever "1" downwards to activate the swivel movement, or upwards to lock the swivel movement.
PARKING BRAKE (fig. 34)
To apply the brake: Press the brake lever, push the pushchair forward gently to ensure the brake has been applied correctly.
To release the brake: lift the lever.
FOOTREST ADJUSTMENT (fig. 35)
Press buttons "a" and adjust the footrest in the required position.
28