Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Care has been taken to assure that your bike has been properly adjusted and lubricated at the factory. It is not
recommended that the user attempt service on the internal components instead seek service from an authorized
service center. However, from time-to-time the outer surfaces may appear dull or dirty, following the instructions listed
below will restore and preserve the original finish.
•
Cleaning metal surfaces may be accomplished by using a soft cotton or terry cloth rag with a light application of
car wax. Do not use aerosol sprays or pump bottles as they may deposit wax upon the console surface.
•
From time-to-time the console surface may collect dust or finger prints. The use of harsh chemicals will destroy
the protective coating and cause a static build up that will damage the components. This surface may be cleaned
with specially prepared chemicals found in most computer supply stores especially made for antistatic surfaces.
It is strongly recommended that you purchase such a cleaning compound.
•
The safely level of the equipment can only be maintained if it is regularly examined for damage and/or wear and tear.
•
Care must be taken when lifting or moving the equipment so as not to cause injury.
•
The brake pad is most susceptible to wear. Before exercising inspect braking system for functionality.
•
Check that all fixings and parts are well fastened.
•
Carefully inspect all parts more susceptible to wear or damage.
•
Immediately replace all defective parts.
•
Keep the device out of use until repaired.
•
Please check if all warning labels are in good condition and able to read. If they are deformed please contact the
distributer to order new sticker.
STORAGE
1. To store the BIKE, simply keep it in a clean dry place.
2. To avoid damage to the electronics, remove the batteries before storing the BIKE for one year or more.
3. To move the BIKE, hold the Handlebar (4) and tilt the BIKE onto the Wheels of the Rear stabilizer (6).
4. Follow the illustrated process below to fold the BIKE.
A. Remove the Lock pin (12). Fold the Rear frame (2) forward. Insert the Lock pin (12) back into the
Rear frame (2) after folding.
52
