PRODUCT USAGE (CONTINUED)
THE MULTIPURPOSE BLADE USAGE
NOTE: The Multipurpose Blade has a spill-resistant seal and can be left in Work Bowl, or
removed before the contents are emptied.
1.
Place the Blade on the power shaft.
2.
Press down firmly on the Blade. You will hear a click when the accessory locks into place.
Liquid level graphics on the side of the Bowl indicate the maximum recommended levels
for thick and thin liquids in the Food Processor.
3.
The Multipurpose Blade has a leak resistant seal, so you may leave the Blade in the Bowl
while pouring out the ingredients.
4.
Remove the Blade by grasping and pulling it straight up.
NOTE: Accessory Blades can only be used with the Work Bowl.
THE PREP BOWL USAGE
NOTE: The Prep Bowl can be used only with the discs and the Dicing Kit.
1.
To use the Prep Bowl, place into the Work Bowl using the two finger grips.
2.
Place the Disc Adapter onto the power shaft.
3.
Place the desired disc on the power shaft. Do not use any Blades with the Prep Bowl.
4.
Install the lid, aligning the tabs and locking it into place.
5.
After processing, remove the Prep Bowl using the two finger grips.
IMPORTANT: Discs and adapters must be removed before removing Bowls.
THE SHREDDING, FRENCH FRY, AND PARMESAN DISCS USAGE
1.
Place the Disc Adapter onto the power shaft.
2.
Slightly rotate the disc until it drops into place onto the Disc Adapter.
3.
Install the lid, aligning the tabs and locking it into place.
4.
To remove Shredding Disc and French Fry Disc, remove the lid and using the 2 finger
grips, lift the disc straight up.
NOTE: The Shredding Disc is reversible. For coarse shredding, place the side labelled
"Medium Shredding" facing up. For fine shredding, place the side labeled "Fine Shredding"
facing up.
5.
To remove the Parmesan Disc after processing, carefully lift off of Disc Adapter.
IMPORTANT: Discs and adapters must be removed before removing Bowls.
THE SLICING DISC USAGE
1.
Place the Slicing Disc on the power shaft.
2.
Slightly rotate the disc until it drops into place.
3.
Install the lid, aligning the tabs and locking it into place.
4.
To remove Slicing Disc, remove lid and using the 2 finger grips, lift the disc straight up.
ADJUSTING THE SLICING THICKNESS
NOTE: This lever only works with the Adjustable Slicing Disc. Changing thickness settings with
other discs or Blades installed will have no effect on operation.
In addition to the position of the lever, it is possible to change the thickness of your slices by
changing pressure on the food item when guiding it into the Feed Tube. Use more pressure for
a thicker slice, or use less pressure for a thinner slice.
7