Preparation Tips - Black and Decker SmartSelect BDPH1200 Manual De Instrucciones

Solid color water based stains
Water based or latex paints
Note: Not recommended for textured paint.

PREPARATION TIPS

f Always stir and strain the material thoroughly before use.
f With any spraying job you should always ensure that
you have properly prepared the surface to get the best
finish. That is, all surfaces are free from dust, dirt, rust
and grease. Lightly pressure wash decks or exterior
surfaces and ensure that they are dry before spraying.
f Even though HVLP sprayers have very little overspray,
it is recommended that you mask all edges and other
areas and use drop cloths to protect your floors and
anything else in the spraying area that you wish to
remain untouched.
f Skin that forms on the top of paint can clog the
sprayer. Remove skin before mixing. Strain with a
funnel with a filter attached or through hosiery to
remove any impurities that could clog system.
f Before starting have gloves, paper towels, rags etc.
available for unexpected spills.
FILLING THE CANISTER (Fig. F)
f Check to make sure that the canister is completely
screwed onto the sprayer.
f Unscrew the quick refill lid (17).
f Stand the sprayer firmly on an smooth and horizontal
surface.
f Pour the properly thinned and strained material to be
sprayed into the side fill canister (Fig. F).
f Clean any residual liquid from the threads or sides
of the canister and sprayer.
f Starting the threads evenly, screw the lid completely
onto the top fill canister. Check the lid to make sure it
is threaded on squarely and completely before picking
up the sprayer.
ON/OFF SWITCH (FIG. G)
The on/off switch is located on the top of the power unit.
Press the switch button to turn on or turn off the power unit.
SMART SELECT NOZZLE SELECTION (FIG. H,
FIG. H1)
There are three spray patterns to choose from:
- Vertical Flat Jet
- Horizontal Flat Jet
- Circular Jet
May require thinning
(More than 2 minute
runout)
To select Vertical Flat Jet, turn
the air cap (5) to horizontal direction
by turning the smart nozzle selector
(3) clockwise until stop.
To select Horizontal Flat Jet, turn
the air cap (5) to vertical direction by
turning the smart nozzle selector (3)
anti-clockwise until stop.
To select Circular Jet, turn the spray width lever (8)
to the icon of minimum.
Note: Spray nozzle can only be assembled in one direction
that the notch of the nozzle (6) must align with the skirt on
spray unit housing (10). Refer to Fig. T1 for proper assembly.
Warning! Risk of injury. Never point the sprayer ay
any part of the body. Never pull the trigger while adjusting
the spray setting.
ADJUSTING WIDTH OF SPRAY PATTERN (FIG. H1)
By turning the Spray Width Lever (8) between the minimum
marking and maximum marking, the width of the spray
patterns can be adjusted accordingly.
FLOW CONTROL KNOB (FIG. I)
The flow control knob (19) regulates the amount of liquid
that can be sprayed. Turning the flow knob clockwise
ENGLISH • 31