Idiomas disponibles
Idiomas disponibles
1.
Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling
• Failure to comply with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts,
• Improper use
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed
Note:
Read the whole text of the operating manual before as-
sembly and commissioning.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
22 | GB
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description
1.
Light switch
2.
Speed setting wheel
3.
On/off switch
4.
Workpiece stop
5.
Workpiece stop screw
6.
Allen key
7.
Saw band
8.
Saw band tightening lever
9.
Handle
10. Wing screw on the handle
11. Protective covers
12. Locking screws
13. Rubber wheels
14. Guide rollers
15. Handle on the vice
15a. Quick adjustment
16. Vice
17. Cylinder-head screws with hexagon socket
18. Cutting angle adjustment
19. Long wing screw
20. Screw for the cutting angle adjustment
21. Locking pin
21a. Nut
22. Swivel arm
23. Work lamp
24. Saw table
25. Holes
26. Carbon brushes
3. Scope of delivery
• Metal band saw
• Saw table (pre-fitted)
• 4 wing screws, long (pre-fitted)
• Allen key (4 mm)
• Allen key (6 mm)
• Operating manual
www.scheppach.com
