Idiomas disponibles
Idiomas disponibles
3. Using hex head driver, turn the front adjustment
screws (A) on each side to raise or lower the front
of the refrigerator.
B
4_
Using the carpenter's
level, make sure front of
refrigerator
is '/_" (6 ram) or '/_bubble higher than
back of refrigerator
and that the refrigerator
is level
from side to side.
Turn stabilizing
legs (B) clockwise
until firmly
against floor.
Replace hinge cover(s).
• Position cover into the outer edge of the hinge.
• Swing the cover toward the cabinet and snap it
into place.
7. Replace the toe grille.
Note
For proper reinstallation,
ensure the "top" marking
on the interior of the toe grille is oriented
correctly.
• Align the toe grille mounting
clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.
Door Removal
Some installations
require door removal to transport
the refrigerator
to its final location.
To avoid
electrical
shock
which
can cause
severe
personal
injury or death, observe
the
following:
• Disconnect
power to refrigerator
before removing
doors. Connect power only after replacing
doors.
To avoid damage to walls and flooring, protect vinyl
or other flooring with cardboard,
rugs or other
protective
material.
MateriaJs
Needed:
• Phillips screwdriver
• %" hex head driver
3_
Unplug power cord from
power source.
Remove toe grille (see page
7).
Remove top hinge cover
from refrigerator
door by
removing
Phillips screw and
retain screw and cover for
later use.
ZIt_
Unscrew -%6" hex head
screws from top hinge to
remove hinge and retain all
screws for later use.
Lift refrigerator
door from
center hinge pin.
Hold freezer door while
removing
hinge pin with
a -%?'hex head drivel.
Remove door from
bottom hinge and retain
hinge pin for later use.
Remove any door shims if
present.
Remove Phillips screws to
remove center hinge and
retain all screws for later
use.
8. Remove bottom hinge or
stabilizing
bracket with _" hex
head driver and retain screws
for later use. Lift out bottom
hinge pin.
