Install The Unit At A Dry Place; Connecting The Controller; Commissioning/Start-Up; Switching On/Off - Oase AquaMax Eco Classic Serie Puesta En Marcha

Installation
 C
• Place the pump horizontally on a stable surface.
• Ensure secure and stable positioning of the pump.
• For muddy or soiled water, we recommend installing the pump or intake-side components
(skimmer, satellite filter, base outlet, etc.) above ground level. This decreases intake of parti-
cles and increases the service life of the impeller unit.
• Only operate the pump when it is covered in at least 10 cm of water. Otherwise it may draw in
air.

The pull rope allows you to simply pull the pump from the water.
− Fasten the pull rope on the bottom filter casing through the round openings and make a
knot.

Install the unit at a dry place


For information, please refer to the operating manual.

Connecting the controller

 D

Commissioning/start-up

NOTE
The unit will be destroyed if it is operated with a dimmer. It contains sensitive electrical compo-
nents.
 Do not connect the unit to a dimmable power supply.
NOTE
Never allow the pump to run dry. Otherwise the pump may be destroyed.
 Only operate the pump when it is submerged or flooded.

Switching ON/OFF

Switching on
The pump must be connected to the controller before the controller is switched on.
• First connect the controller to the mains supply, then switch on the pump at the controller.
Switching off
• Switch the pump off at the controller.
– Disconnect the controller from the mains before performing any work on the unit.
16