Idiomas disponibles
Idiomas disponibles
... central control unit for your video recorder.
Insert two 1.5V HP 7 batteries with the correct polarity as
marked in the battery compartment.
A\Exhausted batteries should be removed from the remote
control
unit as
no
responsibility
is taken
for damage
caused by leaking batteries.
Tuning to TV Stations
So that your recorder can record TV broadcasts, it must be
tuned to the local TV stations or to the special channels of
the regional cable TV systems.
There are two possible methods:
1. Entering channel numbers directly.
2. Using the station search system.
Information
about
the
channel
numbers/special
channel
numbers can be obtained from your dealer, after-sales
serv-
ice or post office.
@ Switch on TV set.
@ Select the programme position for video playback on the
TV set.
— The tuning procedure can be checked on the TV screen.
®@ Point the remote control handset at the recorder.
Tuning to TV Stations by Entering Channel
Num-
bers Directly
@ Press button # and then button C.
— Indication on recorder:
! Proc = Station position
06
= Channel number of a TV station
®@ Enter the required channel number as 2 figures using the
numbered buttons 1...0.
~ The channel number ist stored automatically.
Entering Special Channels
® The table below shows which channel numbers you have
to enter to receive special channels.
Special channels
S$
Numbers to be entered | 8
Special channels
S
Numbers to be entered | 8
9
87
88
89
90
{
1
6
6
1
Special channels
$11/S12|$13)}$14/)
$15
Numbers to be entered
92
93
94
95
$16
96
Special channels
Numbers to be entered
14
Tuning
to TV Stations
using
Automatic
Station
Search System
— The recorder searches the TV channels from channel
1
to channel 80 and then the special channels (indication 81
=$1,82=S2andso
on) fromS 1 toS 20.
® Press button # and then button C.
@ Start the station search by pressing the C button once
more.
— The station search will now start to scan all of the TV chan-
nels and will stop when a station is found. If this station is
not the one required, repeatedly start the station search
until the desired station is found.
Altering Picture Quality
— The recorder will automatically tune to best possible pic-
ture quality. If you wish to alter the picture contours,
® press button < (the picture contours become softer) or
button — (the picture contours become harder).
— lf VPS* appears, the recorder is receiving this additional
signal.
lf VPS flickers or goes out, this indicates bad reception.
Correct this with the buttons — or — until VPS is contin-
uously illuminated and a good picture quality is obtained.
Calling Up the Next and Further Station Positions
@ Press button w or #.
Up to 49 station positions can be allocated to the channel
numbers/special channel numbers of the stations.
* Only for recorders with VPS.
