cecotec BOLERO COOLMARKET TT B1 121 E Manual De Instrucciones página 59

- Do not use sharp objects for cleaning as they may scratch the surface.
Do not use thinner, car detergent, bleach, ethereal oil, abrasive cleaners or organic solvents
-
such as benzene for cleaning. They may damage the surface of the appliance and cause
a fire.
Inside cleaning
- The inside of the appliance must be cleaned frequently. It will be easier to clean when there
is little food inside. To clean the interior you can use a diluted solution of baking soda and
water and then rinse with a damp sponge or cloth, or you can use a specific non-abrasive
cleaning product.
- Dry thoroughly before refitting shelves and drawers. Dry all surfaces and removable parts
thoroughly before replacing them.
- Although this appliance defrosts automatically, a layer of frost may form on the inside
walls of the refrigerator compartment if the door is opened frequently or kept open for
too long. If the frost is too thick, choose a time when the refrigerator is almost empty and
proceed as follows:
1. Remove food and accessories from inside the refrigerator, unplug the appliance from the
mains and leave the doors open. Ventilate the room well to speed up the process.
2. When defrosting is complete, clean the refrigerator as described above.
Warning!
Do not use sharp objects to remove frost from the freezer. Do not reconnect the appliance to
the mains until the interior is completely dry
Door seal cleaning
Keep the door seals clean. Sticky food and drinks can cause the seal to stick to the refrigerator
and break when the door is opened. Clean the seal with a mild detergent and warm water.
Rinse and dry thoroughly after cleaning.
Warning: Do not switch on the appliance until the door seal is completely dry.
How to substitute the LED light
Warning: The LED light must be replaced by a qualified professional or by Cecotec Technical
Support. If the LED light is damaged, follow the steps below:
Unplug the appliance.
1.
Remove the protective cover from the light by lifting it up and pull out the LED light.
2.
Hold the LED light with one hand and pull it with the other hand while pressing the
3.
fastener.
Replace the LED light by snapping it correctly into place.
4.
ENGLISH
Bolero CoolMarket TT B1 121 E
59