Idiomas disponibles
Idiomas disponibles
Reinstalling the Refrigerator Door
I_ Right Door
1. Lower the door onto middle hinge pin (9).
2. Fit top hinge (5) over hinge lever latch (6)and into place.
Rotate lever (4) counterclockwise
to secure hinge.
3. Connect wire harnesses (3).
4. Hook tab on switch side of coner under edge of wire
opening in cabinet top. Position cover (2) into place.
Insert and tighten cover screw (1).
(1).........
_2J
_
(3)
_
(2)
(4) (5)
I_ Left Door
1. Lower the door onto middle hinge pin (10).
2. Fit top hinge (7) over hinge lever latch (8) and into place.
Rotate lever (6) clockwise to secure hinge.
3. Install the grounding screw (5) and connect the three
wire harnesses (4).
4. Push the water supply tube into the hole on the top case
and pull it out on the backplate.
5. Insert the water supply tube (3) into the connector tube
until you see only one scale mark. (Fully insert the tube
over 5/8" (15 mm)).
6. Hook tab on door switch side of cover (2) under edge of
wire opening in cabinet top. Position cover into place.
Insert and tighten cover screw (1).
(2)
_1)
(3).
\\
/
(8)
A CAUTION
Collet
Tube
Insert Line
Clip I
After inserting, pull the tube to
make sure that it is secure and
reinsert the clip.
12
