Idiomas disponibles
Idiomas disponibles
Stopping the alarm / snooze function
• When the alarm is triggered, the alarm symbol
begins to flash and an alarm sounds.
• Press any button (except the SNOOZE/LIGHT button (11)) to stop
the alarm. Otherwise, it will stop automatically after 2 minutes.
Note – Snooze function
While the alarm signal is sounding, press the SNOOZE/LIGHT
button (11) to activate the snooze function. The alarm symbol (7)
/
will begin to flash. The alarm signal will be stopped for 5
1
2
minutes, after which it will sound again.
5.5. Backlight
Note - Permanent backlight mode
Permanent backlight mode is only possible when plugged into
mains power.
• Press the SNOOZE/LIGHT button (11) several times to change
the brightness level (high/low/off).
5.6. Projection
Activating/deactivating
• Press and hold the SNOOZE/LIGHT button (11) for
approximately 3 seconds to activate sustained projection.
• Press and hold the SNOOZE/LIGHT button (11) for
approximately 3 seconds to deactivate sustained projection.
Projection setting
• Turn the projection arm (10) forward/back to project the display
onto the desired wall/ ceiling.
• Press the ROTATE button (19) again to rotate the projection by
0°, 90°, 180° or 360°.
6. Charging function
Warning - Connecting terminal devices
• Before connecting a terminal device, check whether the power
output of the charger can supply sufficient power for the device.
• Ensure that the total power of all connected terminal devices
does not exceed 10 W
• Please refer to the instructions in the operating manual of your
terminal device.
Note
The charging function is only possible when plugged into
mains power.
• Connect your terminal device to a USB charging socket (22) on
the alarm clock using a suitable USB cable.
• The charging progress is displayed on your terminal device.
• Disconnect the terminal device from the USB charging socket
if you want to interrupt charging or if the terminal device is
fully charged.
8
7. Care and Maintenance
(4) or
(5)
Only clean this product with a slightly damp, lint-free cloth and do
2
1
not use aggressive cleaning agents. Make sure that water does not
get into the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operating
instructions and/or safety notes.
9. Technical Data
RCR 110 radio-controlled alarm clock
Measuring range
for temperature
Humidity
measuring range
10. Declaration of Conformity
declaration of conformity is available at the following internet
address: www.hama.com -> 00186332 -> Downloads.
Frequency band(s)
-9° C - + 50° C / 14° F - +122 °F
20 % - 95 %
Hereby, Hama GmbH & Co KG declares that the radio
equipment type [00186332] is in compliance with
Directive 2014/53/EU. The full text of the EU
77.5 kHz
