Bosch HIB82651UC Manual De Instrucciones página 9

Audible signal
Switching on audible signal
o Press and hold the "Light" button for 5 seconds.
o An audible signal sounds and "Snd" appears on the
display panel for 3 seconds.
Switching off audible signal
o Press and hold the "Light" button for 5 seconds.
o "Snd" appears on the display panel for 3 seconds.
Overheating protection
The appliance is equipped with overheating protection. If
high temperatures are measured on the appliance, the
appliance switches automatically to the highest ventilator
setting until the temperature drops again.
o If the hood is switched on, the highest ventilator setting
is set. If the temperature drops again, the appliance
switches back to the previously-selected ventilator
setting.
o If the hood is switched off, the appliance switches
automatically to the highest ventilator setting. If the
temperature drops again, the appliance switches off
automatically.
o While the overheating protection is active, "Auto"
appears on the display panel. The ventilator setting
cannot be reduced in this time.
Cleaning and maintenance
• , WARNING
WARNING
To avoid risk of fire and explosion do not use
flammable liquids or solvents. Always unplug or
disconnect the appliance from the power supply
before servicing.
Do not use steam cleaners to clean the appliance.
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.
• , WARNING
RISK OF BURNS
The appliance will become hot when in use,
especially in the area surrounding the bulbs. Let
cool before cleaning.
,a,
WARNING
RISK OF ELECTRIC SHOCK
Penetrating damp can cause electric shock. Only
clean appliance with a damp cloth. Prior to cleaning,
pull the plug or flip the breaker in the fusebox.
Cleaning agents
To prevent various surfaces from becoming damaged
due to incorrect cleaning agents, follow the specifications
given in the table. Do not use
o cleaning agents that are harsh or scouring,
o cleaning agents with high alcohol content,
o hard scouring pads or sponges,
o high-pressure cleaners or steam cleaners.
Thoroughly rinse all new sponges before use.
Observe all instructions and warnings accompanying
cleaning agents.
Area
Stainless steel
Varnished sur-
faces
Aluminum and
plastic
Glass
Controls
Cleaning agents
Warm soapy water:
Clean with a dish rag and dry with
a soft towel.
Only clean stainless steel with the
grain.
Specific products for stainless
steel care are available from cus-
tomer service or from specialized
retailers. Apply a thin layer of the
care product with a soft cloth.
Warm soapy water:
Clean with a damp dish rag and
dry with a soft towel.
Do not use stainless steel
cleaner.
Glass cleaner:
Clean with a soft cloth.
Glass cleaner:
Clean with a soft cloth. Do not use
a glass scraper.
Warm soapy water:
Clean with a damp dish rag and
dry with a soft towel.
Risk of damage to electronics
due to permeating damp. Never
clean controls with a wet cloth.
Do not use stainless steel
cleaner.