Idiomas disponibles
Idiomas disponibles
Operation
EN
Operating the keys
The controls described here expect the pressing of a (selection) key to be followed by the pres- sing of a
subsequent key.
The next key will need to be pressed within 10 seconds, otherwise the selection will be deleted.
Switching on the hob and cooking zones
1. Press the ON/OFF key (approx. 1 sec.) until the power setting 0
appears and a short signal will sound. The controls are ready for
operation.
2. Put cookware suitable for induction cooking on to the cooking
zone. The pan recognition device will activate the induction coil.
Power setting display of the corresponding cooking zone shows "0".
3. Use the Power setting display (as a key) to select a cooking zone.
The stand-by dot of the cooking zone selected will light up.
4. The slider control must be activated immediately afterwards. A
power setting will be switched on.
See the section on "Worth knowing about the slider (sensor field)".
Press the respective sensor field to change a power setting or to
switch on an additional cooking zone.
Important: the stand-by dot of the cooking zone selected must light up.
As long as no cooking pot is placed onto the cooking zone, the display will altemate between the power
level set and the Pan recognition symbol. If no pot is placed on the cooking zone, it will switch off after 10
minutes for reasons of safety. Please refer to the Section on pan recognition.
Switching off a cooking zone
Use the power setting display (as a key) to select a cooking zone.
The stand-by dot of the cooking zone selected must light up.
5.a) Press the slider area on the far left or
5.b) drag your finger to the left across the slider control to reduce the
power setting to 0
5.c) Press the ON/OFF key. All the cooking zones are switched off.
Switching off the hob
6. Press the ON/Off key of the hob. The hob will be switched off
irrespective of any settings.
Please note:
•The hob will switch off automatically after 10 seconds when all the
cooking zones and the fan are switched off manually and no
key/sensor field is pressed afterwards.
•Fan has an after run function (see chapter "Fan after run")
47
