Idiomas disponibles
Idiomas disponibles
EN
OPERATION
Cooking zones function principle
The hob is fitted with high power induction hotplates. Heat is generated directly at the bottom of the dish,
where it is most needed, without any losses through the glass surface.
The glass surface is not heated directly, but only by return heat transmitted by the pot.
This heat figures as "H" after the hotplate is turned off.
The induction hotplate generates heat from the induction coil, installed underneath the glass surface. The
coil creates magnetic field at the bottom of the pot (which can be magnetized) which in turn originates
whirling flows of current which then heat.
Appropriate cookware
• Induction hotplate will function perfectly only if appropriate pot is used.
• The pot should be in the middle of the hotplate during cooking.
• The appropriate pot is the one which enables induction, for example steel,
enamel or steel alloy. Pots made from steel alloy with copper or aluminium
bottom, or glass pots are inappropriate.
• If you use the pressure pot, keep it under close surveillance until proper
pressure is obtained. Hotplate should first operate on maximum power, then
follow the manufacturer's instructions.
When buying cookware, check if it bears the label "allows induction".
210x190 (SINGLE)
210x190 (BRIDGE)
Ø145-160-200-280
Ø250
Note:
When Bridge function is selected, you can use the created zone in different ways, with one or two pots.
If you use larger pots than the recommended maximum size, the heating time will be longer, because the
heating will propagate from center to edges of the pot by conduction, in this case also the temperature will
be very inhomogeneous.
Magnet test
Use small magnet A to test if the dish bottom is magnetic.
Only dishes where magnet sticks to the bottom are suitable.
Pot recognition
One of great advantages of the induction hotplate is pot recognition.
When the hotplate is on, the power indicator displays . If you place the pot over that hotplate within the
following 10 minutes, the hotplate recognizes the pot and turns on to the pre-set power value.
At the moment you remove the pot from the hotplate, power is suspended. If you place smaller pot upon
the hotplate and it is recognized, the hotplate will only use the amount of energy required to heat the pot
according to its size.
Hotplate may be damaged if:
• empty hop are heated up.
• you don't use the appropriate pots.
• you use clay pots which leave scratches on the glass surface.
• you don't wipe the pot bottom.
The use of bad quality cookware or any adapter for non-magnetic cookware invalidates product
warranty. In this case, the manufacturer cannot be held responsible for any damage caused to
the appliance and / or objects closed to the same.
42
Operation
Ø 110 mm
Ø 145 mm
Ø 110 mm
Ø 145 mm
