Idiomas disponibles
Idiomas disponibles
5 Troubleshooting
Problem
Tool is sluggish.
Chip can only be cut off with
difficulty.
Tool does not switch on.
5.1 Replace carbon brushes
If the carbon brushes are worn, the
motor stops.
Have carbon brushes checked by a tech-
u
nician and replaced.
5.2 Replace the power cable
The power cable may only be re-
placed by the manufacturer or its contract
workshops to prevent safety hazards.
For TRUMPF service addresses, see:
www.trumpf.com
Cause
Cut guides are worn.
Cut guides have broken-out
edges.
Blades are dull.
Chip clipper/cutter plate is dull
or set incorrectly.
Rechargeable battery is empty
or defective.
Power cable is defective.
Carbon brushes are worn.
Translation of the original operator's manual
Remedy
Turn/replace cut guides
u
[} 252].
G
Change blades
u
Lubricate blades and bear-
u
ing pins with "G1" lubricant.
Replacing chip clipper/cut-
u
ter plate or setting it cor-
rectly
Changing rechargeable
u
battery
Replace the power ca-
u
ble [} 17].
Replace carbon
u
brushes [} 17].
6 Repair
Service, changing, and inspection of power
tools must be done properly.
The safety regulations according to DIN
VDE, CEE, AFNOR, and other regulations
valid in individual countries must be adhered
to.
If a connection line must be replaced, have
this repair done by the manufacturer or its
representative to avoid safety hazards.
EN
[} 254].
H
[} 256].
I
[} 252].
F
17
