Mitsubishi Electric SLZ-KF09NA Manual De Instrucciones página 10

1 Select "Maintenance" from the
Main Main menu
Maintenance
Initial setting
Service
Main display:
Cursor Page
F1 F2 F3 F4
2 Select "Manual vane angle" with
Maintenance menu
Auto descending panel
Manual vane angle
3D i-See sensor
Main menu:
Cursor
F1 F2 F3 F4
3 Move the cursor to "Ref. address"
Manual vane angle
Ref. address
Unit No.
Identify unit Check button
Input display:
Cur. Address Check
F1 F2 F3 F4
4 The current vane setting will ap-
Manual vane angle
Select:
Outlet Angle
F1 F2 F3 F4
Manual vane angle
Setting
* Draft reduction
Main menu (refer to page 8), and
press the [SELECT] button.
the [F1] or [F2] button, and press
the [SELECT] button.
or "Unit No." with the [F1] button to
select.
Select the refrigerant address and
the unit number for the units to
the [F2] or [F3] button, and press
the [SELECT] button.
unit.
The vane of only the target indoor
unit is pointing downward.
pear.
Select the desired outlets from 1
through 4 with the [F1] or [F2] but-
ton.
4, (all outlets)"
Press the [F3] or [F4] button to go
through the option in the order of
"No setting (reset)", "Step 1", "Step
2", "Step 3", "Step 4", "Step 5" and
"Draft reduction*".
Select the desired setting.
direction for the "Step 1" setting in
order to reduce a drafty feeling.
The draft reduction can be set for
only 1 vane.
No setting Step 1
Step 3 Step 4
Draft
All outlets
reduction*
Press the [SELECT] button to save the settings.
A screen will appear that indicates the setting information is being trans-
mitted.
The setting changes will be made to the selected outlet.
The screen will automatically return to the one shown above when the
transmission is completed.
Make the settings for other outlets, following the same procedures.
Navigating through the screens
To go back to the Main menu ................ [MENU] button
To return to the previous screen .......... [RETURN] button
A
B
Display
Setting Step 1 Step 2
Display
Setting Step 5 No setting
* The draft reduction can be set for only 1 vane.
The setting is enabled only for the last vane that was set.
Step 2
Step 5
1 Going to the Manual vane setting
mode
Press the button.
(Start this operation from the status
of remote controller display turned
off.)
"FUNCTION" is lit and "1" blinks.
(Fig. 1)
Press the button to select "2",
and then press the button.
2 Selecting the vane number (Fig. 2)
Press the buttons to select the
vane number A, and then press
the button.
3 Setting the vane angle (Fig. 3)
Press the buttons to select the
vane angle B.
Point the wireless remote controller
toward the receiver on the indoor
unit, and then press the
button.
Step 3 Step 4
No display
Draft reduction*