Idiomas disponibles
Idiomas disponibles
Note:
If you use a grass blade, it must balance
approximately 10 cm /4 in above the ground.
WARNING:
safety chapter before you operate the
product.
Fuel
To use fuel
CAUTION:
cycle engine. Use a mixture of gasoline
and two-cycle engine oil. Make sure to use
the correct quantity of oil in the mixture.
Incorrect ratio of gasoline and oil can cause
damage to the engine.
Gasoline
CAUTION:
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
CAUTION:
more than 10% ethanol concentration (E10).
This can cause damage to the product.
CAUTION:
This can cause damage to the product.
•
Always use new unleaded gasoline with a minimum
octane number of 90 RON (87 AKI) and with less
than 10% ethanol concentration (E10).
•
Use gasoline with a higher octane number if you
frequently use the product at continuously high
engine speed.
•
Always use a good quality unleaded gasoline/oil
mixture.
Two-cycle engine oil
•
Use only the two-cycle engine oil of high quality,
especially HUSQVARNA two-cycle oil. Use only the
oil of an air cooled engine.
•
Mixture ratio 50:1 (2%).
•
Oil of low quality and high oil/fuel ratio can decrease
the lifetime of catalytic converters.
•
Speak to your dealer when you select an oil.
•
If Husqvarna two-stroke oil is not available, you can
use another two-stroke oil of good quality that is
intended for air cooled engines. Contact your dealer
when you select oil.
12
Operation
Read and understand the
This product has a two-
Do not use gasoline with an
Do not use gasoline with
Do not use leaded gasoline.
•
Do not use the two-stroke oil for water-cooled
outboard engines. The two-stroke oil is sometimes
referred to as outboard oil.
Gasoline, liter
5
10
15
20
To make the fuel mixture
Note:
Always use a clean fuel container when you mix
the fuel.
Note:
Do not make more than 30 days quantity of fuel
mixture.
1. Add half of the gasoline quantity.
2. Add the full quantity of oil.
3. Shake the fuel mixture to mix the contents.
4. Add the remaining gasoline quantity.
5. Shake the fuel mixture to mix the contents.
6. Fill the fuel tank.
To add fuel
WARNING:
objects near fuel. Before you add fuel, stop
the engine and let it cool for minutes.
WARNING:
the fuel tank cap slowly to release unwanted
pressure.
WARNING:
the fuel tank cap carefully. Move the
machine away from the refuelling area and
the power before you start the engine.
•
Always use a fuel container with an anti-spill valve.
•
Make sure that the area near the fuel tank cap
is clean. Contamination in the tank can cause
operating problems.
Oil, liter
2%(50:1)
0,1
0,2
0,3
0,4
Do not smoke or put hot
When you add fuel, open
After you add fuel, tighten
1544 - 005 - 03.04.2023
