Idiomas disponibles
Idiomas disponibles
ST6
Professio na l A nalo gu e Mon itorin g System - User Manual
Quick-start guide
1. Before you do anything, check that the loudspeakers and audio source (console, etc.) are in the Off position and that all
settings at the back of the loudspeakers are in the 0 position. Ensure that the sensitivity switch is in the +4dBu position.
2. Connect the audio signal from the source to the loudspeakers, using the XLR inputs.
3. Use the power cable supplied to connect the loudspeaker to the mains.
4. Power on the audio source and check that the output level of the audio source connected to the loudspeaker is set to - ∞
or a very low level.
5. Switch on the loudspeakers. The loudspeakers are now in "Stand-by" mode.
6. Increase the level of the audio source until the signal is detected by the loudspeakers, so that they automatically switch
into "On" mode.
After the loudspeakers are powered on and after the automatic stand-by mode is enabled, the audio signal
detection circuit in the loudspeaker will automatically switch from "Stand-by" to "On" mode, a few seconds
after a signal is received.
7. Once you have finished your recording, mixing or mastering session, we recommend switching off the equipment in the
following order:
a. Switch off the loudspeakers
b. Switch off the audio sources
Solo6
Solo6 is an active 2-way nearfield professional loudspeaker (2 internal amplifiers), comprising a Focal 6
midrange speaker driver with 'W' composite sandwich cone, fitted with a large-section laminar port and a Focal pure Beryllium
inverted dome tweeter (fig. A).
Twin6
Twin6 is an active 2.5-way semi nearfield professional loudspeaker (3 internal amplifiers), comprising two Focal 6
speaker drivers with 'W' composite sandwich cone, fitted with a large-section laminar port and a Focal pure Beryllium inverted
dome tweeter. Both 6
" (16.5cm) speaker drivers reproduce the bass but only one of them (you can choose the positioning)
1/2
reproduces the "midrange" frequencies (fig. B).
Sub12
Sub12 is an active subwoofer for professional monitoring systems. The transducer used is a Focal 13" (33cm) subwoofer with
'W' composite sandwich cone, fitted with a large-section laminar port (fig. F).
Sub12 can be used:
- in addition to bass or sub-bass for stereo + subwoofer systems (2.1 or 2.2). For this purpose, the rear panel connectivity of the
Sub12 allows you to connect a traditional stereo source (Left In and Right In), but also to pick up a signal (Left Out and Right
Out) processed via the "high-pass" crossover included in the Sub12, designed to supply any linked "satellite" loudspeakers.
- as an LFE (Low Frequency Effect) channel for use in a multichannel system (5.1, 5.2, 6.1, etc.) via a specific LFE input located
on the rear panel of the Sub12. As an LFE channel, the low-pass crossover is no longer active.
Trio6
Trio6 is an active 3-way professional nearfield loudspeaker. It comprises an 8-inch (20.3cm) subwoofer with 'W' composite
sandwich cone fitted with a large-section laminar port, a 5-inch (12.7cm) woofer with 'W' composite sandwich cone, and a
1-inch (2.5cm) tweeter with pure Beryllium inverted dome.
27
" (16.5cm) bass/
1/2
" (16.5cm)
1/2
