ESAB MobileFeed 201 AVS Instrucciones De Uso página 13

4 INSTALLATION
1. Release the pressure roll assembly lever (1) and lift the pressure roll assembly (2) up.
2. Remove the knurled screw (3) while holding the drive roll (4).
3. Check and install the correct guide tubes.
4. Keep or replace the drive roll (4) with the required size; the designation is marked on the
side of the roll facing out.
5. Put the knurled screw (3) back in position on the drive roll (4) and tighten it.
6. Thread the wire and fasten the pressure roll assembly (2).
4.4 Installing the welding wire
CAUTION!
Turn off the power source and the wire feeder.
0558 012 084 - 13 - © ESAB AB 2015