Idiomas disponibles
Idiomas disponibles
4 INSTALLATION
Maximum
Standard spindle hub
Standard spool
Maximum welding current
Maximum gas inlet pressure
Wire diameters
Hard
Soft
Cored
Motor type
Brake type (wire)
Control
Feed system
On-Off switch
Ramp start
Height × Width × Length
Weight (with contactor, without spool) 28 lbs (12.7 kg)
Enclosure class
Enclosure class
The IP code indicates the enclosure class, i.e. the degree of protection against penetration
by solid objects or water.
Equipment marked IP 23S is intended for indoor and outdoor use; however, should not be
operated in precipitation.
4
INSTALLATION
4.1
Receiving and handling
Before installing this equipment, clean all packing material from around the unit and carefully
inspect for any damage that may have occurred during shipment. Any claims for loss or
damage that may have occurred in transit must be filed by the purchaser with the carrier. A
copy of the bill of lading and freight bill will be furnished by the carrier on request if occasion
to file claim arises.
0558 012 084
MobileFeed 201 AVS
100 V DC (113 V peak)
2" (5.1 cm) ID
8" (20.3 cm) OD
320 A at 60% duty cycle
250 A at 100% duty cycle
75 psi (5.2 Bar)
.030" (0.8 mm), .035" (0.9 mm),
.045" (1.2 mm), .052" (1.4 mm),
1/16" (1.6 mm)
.035" (0.9 mm), 3/64" (1.2 mm),
1/16" (1.6 mm)
.030" (0.8 mm), .035" (0.9 mm),
.045" (1.2 mm), .052" (1.4mm),
1/16" (1.6 mm), 5/64" (2.0 mm)
DC permanent magnet pre-lubricated, enclosed
Drag
Solid state
Push
Standard
Standard
14.50" × 7.375" × 18.50"
(368.3 × 187.3 × 470 mm)
IP23S
- 11 -
© ESAB AB 2015
