Idiomas disponibles
Idiomas disponibles
OPERATION INSTRUCTIONS
• Use waste material to practise your skills and
to learn operating the machine first.
• When drilling through, adjust the table to
make sure that the drill is alligned with the
opening in the centre of the table. lf required,
mark the position on the front side of pillar
and table in case the table should be set in the
same position at a later time.
• Securely tighten the workpiece. Toppling,
turning or sliding not only results in a rough
drilling hole, it al so in creases the risk of the
drill breaking off.
• Use a piece of waste wood as a backup to re-
duce the risk of the workpiece splintering and
to protect the drill tip.
• Place flat workpieces on a wooden under-
ground and clamp securely to the table to pre-
vent them from turning. Support workpieces
that are irregular of shape and cannot be put
flat onto the table.
• Use the lift handles to bring the drill lift
downwards. Slowly feed the dril i'nto thework-
piece.
• Drill slowly when the drill is about to break
through the workpiece to prevent splintering.
SWITCHING ON AND OFF
To switch the machine on, set the on/off switch
to '1'. To switch the machine off, set the on/off
switch to '0'.
MAINTENANCE
The machine does not require any special
maintenance.
• Regularly clean the ventilation slots.
LUBRICATION
• Turn the drill shift to the maximum drilling
depth once per 3 months and grease it slightly
with oil.
12
TECHNICAL DATA
TB512A
VOLTAGE-FREQUENCY
SWING
MOTOR POWER
SPINDLE SPEED
NUMBER OF SPEEDS
TABLE SIZE
BASE SIZE
CHUCK STROKE
CHUCK CAPACITY
WEIGHT
TB658A
VOLTAGE-FREQUENCY
SWING
MOTOR POWER
SPINDLE SPEED
NUMBER OF SPEEDS
TABLE SIZE
BASE SIZE
CHUCK STROKE
CHUCK CAPACITY
WEIGHT
TC658A
VOLTAGE-FREQUENCY
SWING
MOTOR POWER
SPINDLE SPEED
NUMBER OF SPEEDS
TABLE SIZE
BASE SIZE
CHUCK STROKE
CHUCK CAPACITY
WEIGHT
TC734A
VOLTAGE-FREQUENCY
SWING
MOTOR POWER
SPINDLE SPEED
NUMBER OF SPEEDS
TABLE SIZE
BASE SIZE
CHUCK STROKE
CHUCK CAPACITY
WEIGHT
120 V ~ 60 Hz
8,1" (208 mm)
300 W
(760 - 3 070) r/min
5
160 mm x 160 mm
291 mm x 183 mm
2" (50 mm)
1/2" (13 mm)
16,5 kg (36,5 lb)
120 V ~ 60 Hz
10" (252 mm)
550 W
(220 - 2 450) r/min
12
200 mm x 195 mm
355 mm x 235 mm
2,3" (60 mm)
5/8" (16 mm)
38 kg (83,7 lb)
120 V ~ 60 Hz
13" (330 mm)
550 W
(210 - 3 840) r/min
16
270 mm x 270 mm
273 mm x 456 mm
3,1" (80 mm)
5/8" (16 mm)
60 kg (132 lb)
120 V ~ 60 Hz
15" (380 mm)
750 W
(250 - 3 000) r/min
12
300 mm x 300 mm
300 mm x 500 mm
3 5/32" (80 mm)
3/4" (19 mm)
82 kg (180,7 lb)
