Idiomas disponibles
Idiomas disponibles
• Pushdownontheshiftrod(andshiftarmassem-
bly)asfarasitwillgo.Holditinthisposition.
• Thread theferruleupordowntheshiftrodas
necessary u ntil t heferrulelinesupwiththeupper
holeintheshiftlever. R efertofigure9.
• Insert f errule intotheupper holeintheshiftlever
fromtherightsidewhen adjustment is correct,
Secure withflatwasher a ndhairpin clip.
• Before operating thesnowthrower, c heckforcor-
rectadjustment ofthetraction drivecontrol a sin-
structed intheFinal A djustment section.
CARBURETOR
&
WARNING: If any adjustments are made to
the engine while the engine is running (e.g.
carburetor), keep clear of all moving parts.
Be careful of heated surfaces and muffler.
If you think your carburetor needs adjusting,
see your nearest authorized Tecumseh
Service Outlet.
SHAVE PLATE AND SKID SHOES
The shave plate and skid shoes on the bottom of the
snow thrower are subject to wear. They should be
checked periodically and replaced when necessary.
• To remove skid shoes, remove the four carriage
bolts, belleville washers and hex nuts which attach
them to the snow thrower.
•
Reassemble new skid shoes with the four carriage
bolts, belleville washers (cupped side goes against
skid shoes) and hex nuts. Make certain the skid
shoes are adjusted to be level.
• To remove shave plate, remove the carriage bolts,
belleville washers and hex nuts which attach it to
the snow thrower housing. Reassemble new
shave plate, making sure heads of the carriage
bolts are to the inside of the housing. Tighten
securely.
Self-Tapping
Cover
Screws
/
FIGURE 21
•
Unthread the bottom of the auger cable from the
top of the cable, leaving the hex nut in place.
•
Remove the six lock washers and hex nuts which
attach the auger housing assembly to the frame.
See figure 22.
I
, LockWashers
Hex Nuts
Franle
FIGURE 22
Auger
Assembly
BELT REMOVAL
AND REPLACEMENT
_lb
ARNING:
Disconnect
the spark plug wire
from the spark plug and ground.
AUGER BELTS
• To remove and replace either the rear or front
auger drive belt, proceed as follows.
• Disconnect the chute crank at the chute assembly
by removing the cotter pin and flat washer.
•
Remove the plastic belt cover on the front of the
engine by removing two self-tapping screws. See
figure 21.
•
Separate the housing from the frame assembly by
standing in the operating position and lifting up on
the handles. The frame and housing will separate,
and the rear auger drive belt will come off the
pulleys. See figure 23.
• To remove the front auger drive belt, push the idler
pulley to the left, and lift front auger drive belt from
the front auger pulley. See figure 23. Replace both
auger drive belts by following the preceding
instructions.
NOTE: When reassembling the two halves of the unit,
make sure that the auger drive cable is routed through
the cable roller guide.
18
