Garland HUNTER 1269 SML Manual De Instrucciones página 44

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
English
If after a few tries the engine does not start, follow the
instructions for starting cold-starting the engine.
6.4. STOPPING THE ENGINE
6.5. TRACTION DRIVE
Press the traction handle against the handlebar, as
shown in the figure, and the mower traction will start
operating.
6.6. CHECKPOINTS AFTER STARTING THE MACHINE
It is important to pay attention to the possible
individual parts or and the temperature of the
machine. If you detect any anomaly in the machine
immediately stop and check it carefully.
In case of any malfunction or problem take the
machine to a service technician to be repaired.
Under no circumstances must you continue to use the
machine if the operation does not seem appropriate.
Do not use the machine if it is damaged or improperly
adjusted.
Turn of the engine by
releasing the safety switch.
7. USING THE MACHINE
Use this machine only for the designated
purposes. Using this chainsaw for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
Do not start the machine in a room or
enclosure.
The exhaust gases and fuel and oil vapors contain
carbon monoxide and harmful chemicals. In case of a
concentration of gases produced by poor ventilation,
remove all that impedes the flow of clean air to
improve ventilation from the work area and not return
to work in the area unless you have properly ventilated
area and have clear that ventilation is sufficient so
that does not happen this concentration again.
Work only in daylight or good artificial light. Do not use
this machine at night, with fog or with a low visibility
which do not allow you to clearly see the working
area.
Whenever possible, avoid using this machine when
the ground is wet. Pay special attention if you use this
machine when it is raining or after it has rained, as
the ground will be slippery and you could slip and fall.
Do not use this machine on slopes greater than 15°.
Cutting on hilly areas can be dangerous.
Be alert when you walk on slopes or wet grass. Slopes
always cut horizontally, not cut bottom up or top down.
Be especially careful when changing direction on a
slope.
Never cut with the mower in reverse or by pulling it.
Be alert when you back up or pull the mower towards
you.
44/172
loading