Husqvarna K970 II Chain Manual De Instrucciones página 17

Pendulum technique
• The cut is made using a pendulum motion and the
saw is only held straight at the ends of the cut. Use the
hand guard as a break point/stop.
OPERATING
Cutting holes
NOTICE! If the upper horizontal cut is made before the
lower horizontal cut, the work piece will fall on the blade
and jam it.
As it is usually a question of large and heavy pieces that
are cut when using the diamond chain saw the forces are
so great that jamming can result in irreparable damage to
both the bar and chain.
Plan the work so that you do not get crushed by the bar
when the pieces fall apart. Planning is also extremely
important for your own safety!
• First make the lower horizontal cut. Now make the
upper horizontal cut. Finish with the two vertical cuts.
• When cutting out large holes it is important that the
piece to be cut out is braced so that it cannot fall
against the operator.
3
2 2
1
–
English 17