Idiomas disponibles
Idiomas disponibles
English
Owner´s manual
•
5. ASSEMBLY
ATTENTION
Before putting the unit into operation, remove all packaging material and transport locks from the unit.
Check that the contents of the package are complete and undamaged. If possible, keep the packaging
until the warranty period has expired.
Fig. 1
Assembly of components
1. Assembly of the support bracket: Place the part (B) with the hex head bolt (C) and secure it with one
of the nuts. (Fig. 1)
2. Wheel assembly: Insert the wheel bolt (F) through the hole in the wheel (E) and insert it through the
hole in the wheel coupling. Secure the wheel (E) with the nut (D). Repeat these steps to mount the
second wheel.
ATTENTION: Wrench and screwdriver not included.
Installation of the device
For safe and fault-free operation of the device, the installation site must meet the following requirements:
•
The floor must be firm, flat and level. Do not place the unit in a hot, humid or very humid environment
or near flammable material.
•
The socket outlet must be easily accessible so that the mains plug can be disconnected in case of
emergency. The use of extension cords is not recommended. Long power cords may cause a voltage
drop and prevent the motor from operating.
•
Operate the compressor in a ventilated area so that the compressor can cool properly.
•
Check and tighten all bolts, fittings, etc., before operating the compressor.
•
To avoid loss of power and overheating, it is best to use an extra air hose instead of extension cords to
reach the work area.
26
A
B
D
C
Fig. 2
E
F
