Idiomas disponibles
Idiomas disponibles
English
Owner´s manual
•
RISK OF EXPLODING. Always drain the air compressor tank daily or after each use. If the tank
27.
develops a leak, replace the air compressor. Never use the compressor after detecting a leak. Never
modify the factory settings of the air compressor that control tank pressure or any other function.
28. The air compressor must be used in a suitable environment (with good ventilation and a temperature
between + 5o and + 40o C) and not in areas with dust, acids, fumes and explosives.
29. Do not use this machine for any other use other than that indicated in these instructions. Failure to
comply with the general rules and instructions in this manual does not imply that the manufacturer is
responsible for any damage. A product that stops working must be disposed of in an environmentally
friendly way and in accordance with local regulations.
3. SPECIFIC WARNINGS AND PRECAUTIONS
1.
Make sure all tools and equipment used with the air compressor are rated for the proper capacity.
Do not use any tool or equipment that will not work from 0 to 115 psi.
2.
Do not leave the compressor unattended for an extended period of time while it is plugged in.
Disconnect the compressor after working.
3.
Keep the compressor well ventilated. Do not cover the compressor during use.
4. DRAIN THE AIR COMPRESSOR DAILY. Do not allow moisture to accumulate inside the air compressor.
5. MAINTAIN A SAFE WORK ENVIRONMENT. Keep work well lit. Make sure there is adequate adjacent work
space. Always keep the work area free of obstructions, grease, oil, trash, and other debris. Do not use the
air compressor in areas near flammable chemicals, dusts, and vapors.
6.
AVOID INJURIES. Never point the airflow valve at people or animals.
7.
DO NOT ALTER OR REMOVE THE FACTORY SEALED PRESSURE RELEASE VALVE.
IMPORTANT INFORMATION YOU SHOULD KNOW ABOUT YOUR COMPRESSOR
All compressors are equipped with a safety valve that trips in case of malfunction of the
•
pressure switch to ensure the safety of the machine.
When installing a tool, the outlet air flow must be shut off, using the pressure regulator.
•
When using compressed air, you must know and comply with the safety precautions to be
•
taken for each type of application (inflation, pneumatic tools, painting, etc).
24
24
