Idiomas disponibles
Idiomas disponibles
*
Always be sure aft components
are mounted
properly
and
securely before using tool.
*
Always handle
the saw blade
with care when mounting
or
removing # or when removing the diamond knockout.
*
Always wait until the motor has reached furl speed before starting
a cut.
*
Always keep handles dry, clean and free of oil and grease. Hold
the tool firmly with both hands when in use.
Always
be alert
at all times,
especially
during
repetitive,
monotonous operations. Always be sure of position of your hands
relative to the blade.
Stay clear of end pieces that may fall after cutting off. They may
be hot, sharp and/or heavy, Serious personal injury may result.
Replace or repair damaged cords. Make sure your extension cord
is in good condition. Use only 3-wire extension cords that have
3-prong grounding-type plugs and 3-pole receptacles that accept
the tool's plug.
*
An extension
cord
must
have adequate
wire size (AWG
or American
Wire Gauge) for safety.
The smaller the gauge
number of the wire, the greater the capacity of the cable, that is
16 gauge has more capacity than 18 gauge. An undersized cord
will cause a drop in line voltage resulting in loss of power and
overheating. When using more than one extension to make up the
total length, be sure each individual extension contains at least
the minimum wire size. The following table shows the correct size
to use depending on cord length and nameplate ampere rating.
If in doubt, use the next heavier gauge. The smaller the gauge
number, the heavier the cord.
Ampere Rating
More
Not More
Than
Than
0
6
6
10
10
12
12
16
Minimum Gauge for Cord Sets
Volts
Total Length of Cord in Feet {meters)
120V
25 (7.6)
50 (15.2) 1100 (30.5)_150 (45.7)
240V
50 (15.2)
100 (30.5)
200 (61.0)|300
(91.4)
AWG
18
16
18
16
16
16
14
12
16
14
14
12
14
12
Not Recommended
_,CAUTION:
Blades coast after turn off. Serious personal injury
may result.
WARNING: ALWAYS wear proper personal
hearing protection
that conforms
to ANSI $12.6 ($3.19) during
use. Under some
conditions
and duration
of use, noise
from this product
may
contribute to hearing loss.
A WARNING:
ALWAYS
use
eye protection.
All users
and
bystanders
must
wear eye protection
that conforms
to ANSI
787. 1.
AWARNING:
ALWAYS
USE
SAFETY
GLASSES.
Everyday
eyeglasses
are
NOT safety
glasses.
Also
use face or dust
mask ff cutting operation is dusty, ALWAYS wear certified safety
equipment:
* ANSI Z87.1 eye protection (CAN/CSA Z94.3).
* ANSI S12.6 (S3.19) hearing protection.
* NIOSH/OSHA respiratory protection.
AWARNING:
Some
dust created
by power
sanding,
sawing,
grinding, drilling, and other construction activities contains chemicals
known in the state of California to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals are:
* lead from lead-based paints,
