Idiomas disponibles
Idiomas disponibles
NOTICE
The forced relay switching states ACTIVE and INACTIVE for SSM/SBM do not indicate the
pump status!
8.1.5
Software version
The current software version of the module can be called up via the pump display. Select menu:
8.1.6
Additional Wilo-Connect module
Extensions under preparation
The following extensions are under preparation and still don't work:
•
Wilo-Connectivity Interface
Slot for additional modules (below the lockable module cover)
CAUTION! Do not connect any modules and leave the setting in the "Stacked WCM" menu at "No"!
8.2
Settings for pumps without suitable display
For pumps without a suitable display to show the configuration of the Wilo-Connect module BMS, default
settings are active when the module is connected.
Standard settings
•
Analogue input: 0-10V with off
•
Digital input: Ext. OFF
•
Digital output: SSM only errors
–
Relay active delay: 5s
–
Relay inactive delay: 5s
–
Relay test ctrl: not activated
9
Maintenance
The modules described in these instructions are maintenance-free.
10
Faults, causes and remedies
Repair work may only be carried out by qualified personnel!
DANGER
Risk of fatal electrical shock!
Ensure there are no risks arising from electrical current!
• The pump must be voltage-free and secured against unauthorised reactivation prior to
any repair work.
• Damage to the mains connection cable may only be repaired by a qualified electrician.
Installation and operating instructions • Wilo-Connect module BMS • Ed.02/2023-10
WCM BMS
SW version
WCM BMS
Stacked WCM
en
47
