Hama Nano Instrucciones De Uso página 5

Warning – Batteries
• Remove the batteries from products that are not being used for an extended period
(unless these are being kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries or heat them up.
• Never open, damage or swallow batteries or allow them to enter the environment.
They can contain toxic, environmentally harmful heavy metals.
• Remove spent batteries from the product and dispose of them without delay.
• Avoid storing, charging and using in extreme temperatures and at extremely low
atmospheric pressures (such as at high altitudes).
• Ensure that batteries with damaged housings do not come into
contact with water.
• Keep batteries out of the reach of children.
4. First steps - Inserting the batteries
Note
• Alkaline batteries are recommended. Use two batteries of the type "AAA" (LR 03/
Micro).
• Remove the battery cover on the back of the universal remote control (A).
• Insert the batteries, observing the "+/-" marks for polarity (B).
• Close the battery compartment (C).
Note: Code memory
• Each programmed code or taught-in button is retained even during battery
replacement.
Note: Energy saving function
• The remote control switches itself off automatically if a button is pressed for longer
than 15 seconds. This prolongs the life of the batteries if the remote control is stuck
in a place where the buttons are pressed permanently, e.g. between sofa cushions.
Note: Low battery display
• This remote control indicates when the batteries are getting low.
• If the status LED ashes 2 times after a button is pressed, the batteries are weak
and should be replaced promptly.
5. Setup
Note
• For proper infra-red transmission, always hold the remote control in the
approximate direction of the device to be operated.
• You cannot operate a device with the universal remote control while it is in Setup
mode. Exit Setup mode and select the device to be operated using the device
selection buttons.
• Please note that the remote control emits infra-red signals. These are not visible
to the human eye.
The remote control can control 2 different types of devices, TV and STB. To switch
between device types, press the Setup button brie y (<3 seconds).
• TV mode:You can select the green or red LED colour for the TV mode. If you have
de ned the TV mode with one of the two colours, the status LED lights up in this LED
colour every time you press the button again.
• STB mode:You can use the respective other LED colour for STB mode. If you activate
the STB mode, the status LED lights up in this LED colour every time you press the
button again.
5.1 Brand-specific code search
With the brand-speci c code search, you can reduce the search to the codes for the
brand of your device. The following overview shows you which brand is represented by
which button.
For TV sets
Button
BACK
HOME
MENU
REW
PLAY/PAUSE
FF
VOL+
CH+
VOL-
CH-
DISNEY+
Brand
Panasonic, TV
Sony, TV
Grundig, TV
Toshiba, TV
Hisense, TV
Telefunken, TV
TCL, TV
Samsung, TV
LG, TV
Philips, TV
(All TV brands)
3