Parkside PLSA 20-Li A1 Traduccion Del Manual De Instrucciones Originale página 18

GB IE
using only identical replace-
ment parts. This will ensure that
the safety of the power tool is
maintained.
Special safety directions for
battery-operated tools
• Ensure that the device is switched
off before inserting the battery.
Inserting a battery into a power
tool that is switched on may re-
sult in accidents.
• Recharge the batteries indoors
only because the battery charger
is designed for indoor use only.
• To reduce the electric shock ha-
zard, unplug the battery charger
from the mains before cleaning
the charger.
• Do not subject the battery to
strong sunlight over long periods
and do not leave it on a heater.
Heat damages the battery and
there is a risk of explosion.
• Allow a hot battery to cool be-
fore charging.
• Do not open up the battery and
avoid mechanical damage to the
battery. Risk of short circuit and
fumes may be emitted that irritate
the respiratory tract. Ensure fresh
air and seek medical assistance.
• Do not use non-rechargeable bat-
teries!
• Do not use any accessories that
are not recommended by PARK-
SIDE. This can result in electric
shock or fi re.
Observe the safety informati-
on and notes on charging
and proper use as shown in
the instruction manual for your
battery and charger from the Park-
side X 20 V TEAM or X 12 V TEAM
series.
18
A detailed description of the char-
ging process and further informa-
tion can be found in the separate
operating instructions.
Operation
The device can either be connected to the
mains power supply or optionally be ope-
rated with X 20 V Team or X 12 V Team
batteries.
Connecting the mains
power supply
1. Plug the power adapter (9) into the so-
cket.
2. Insert the plug (10) into the power
connection (13) on the device.
Removing/inserting the
20 V battery
1. To insert the battery (12), push the bat-
tery along the guide on the back of the
device. You will hear it click into place.
2. To remove the battery (12) from the de-
vice, press the release buttons (11) on
the battery and pull the battery out.
Removing/inserting the
12 V battery
To operate the device with 12 V batteries,
fi rst you will have to insert the 12 V adap-
ter.
Inserting the 12 V adapter
1. Remove the 12 V adapter (8) from
the side of the device as necessary by
pushing the latch (7) on the bottom of
the 12 V adapter away from the device
and pulling up on the 12 V adapter.