MEGABRAS MD-5060x Guia Del Usuario página 21

Paper
White side
Yellow side
Battery charger
This equipment has an intelligent built-in circuit that controls the battery charge
and doesn't allow the equipment to operate during the charging process. In
order to charge the battery, follow this procedure:
•
Verify that the ON/OFF2 switch is switched off.
•
Connect the power supply cable plug into INPUT'. After a while, the lumi-
nous indicator LED@ will blink alternatively in green and red during one sec-
ond, while the charger verifies the initial condition of the battery to select the
optimised parameters of the charge.
The following chart summarizes the meaning of LED luminous indications:
Green and red
flashing alternatively
Permanent red
Flashing red
Permanent green
Flashing green
Note: The battery looses part of its charge while being stored. Thus, before using the
insulation tester for the first time, or after a time being out of use, the battery should be
recharged.
This printer uses 37mm-wide thermal paper, which comes in a
33mm-diammeter reel. The figure shown below indicates how
to put the paper. Press the key (, (until the paper appears).
To remove the old paper reel, cut the paper next to it and
press the key (. The removal used-reel operation must be
carried out in this way due to the fact that the paper movement
is in one-way only, that is, the paper can be moved in one
direction only.
Test of the initial condition of the battery when plugging the mains,
during one second.
Battery under charge.
Charging current is less than normal.
The charging process has been successfully finished. Battery OK.
The charging process has finished, nevertheless the battery hasn't
received the complete charge.
23