Parkside Performance PPTSA 20-Li A1 Traduccion Del Manual De Instrucciones Originale página 34

GB MT
Observe the safety informati-
on and notes on charging
and proper use as shown in the
instruction manual for your battery
and charger from the (Parkside)
X 20 V Team series. A detailed de-
scription of the charging process and
further information can be found in
the separate operating instructions.
Safety information for all saws
SAWING METHOD
a) DANGER! Do not put your
hands in the cutting area or on
the saw blade. If you hold the saw with
both­hands,­they­cannot­be­injured­by­
the saw blade.
b) Do not reach underneath the
workpiece.­The­protective­hood­cannot­
protect you from the saw blade under
the workpiece.
c) Adjust the cutting depth to the thickness
of the workpiece. Less than one full
tooth height should be visible below
the workpiece.
d) Never hold the workpiece you want
to saw in your hands or over your
leg. Secure the workpiece in a sturdy
support. It is important to fasten the
workpiece securely to minimise the
risk of physical contact, the saw blade
jamming­and­loss­of­control.
e) Hold the electric tool by the insulated
gripping surfaces when performing
work in which the cutting tool may
come into contact with hidden wiring.
Contact­with­a­live­wire­also­causes­
a charge in metal parts of the electric
tool and results in an electric shock.
f) When performing longitudinal cuts,
always use a stop or a straight edge
guide.­This­improves­the­cutting­
34
precision while minimising the
possibility­of­the­saw­blade­jamming.
g) Always use the right size saw blades
with the appropriate locating holes
(e.g. diamond or round). Saw blades
that­do­not­fit­in­the­saw­fitting­parts­
run unevenly and lead to a loss of
control.
h) Never use damaged or incorrect
saw blade washers or screws.­The­
saw blade washers and screws were
designed­specifically­for­your­saw­
to ensure optimal performance and
dependability.
Further safety instructions
for all­saws
SPRING-BACK – CAUSES AND
CORRESPONDING SAFETY INSTRUCTIONS
• Spring-back­is­the­sudden­reaction­
caused­by­a­jammed,­stuck­or­
improperly aligned saw blade resulting
in­an­out-of-control­saw­lifting­and­
moving out of the workpiece and
towards the operator.
• If the saw blade snags or gets caught
in the closing sawing gap or sticks, it
will­jam,­and­the­motor­force­will­kick­
the saw back towards the operator.
• If the saw blade is twisted in the saw
cut or incorrectly aligned, the teeth of
the rear edge of the saw blade can
jam­in­the­wood­surface,­causing­the­
saw blade to move out of the sawing
gap and the saw to recoil in the
direction of the operator.
Spring-back­is­caused­by­wrongly­or­
incorrectly operating the saw. It can
be avoided by suitable precautionary
measures, such as those described below.