Idiomas disponibles
Idiomas disponibles
TP3 COND
1.
GENERAL INSTRUCTIONS
• The instruction manual is an integral part of the product and provides a description of everything that must be followed during installation,
use and maintenance.
• This unit must only be used for its intended purpose.
• This unit is designed to heat water to a temperature below boiling point at atmospheric pressure and must be connected to a
heating system compatible with its performance, characteristics and heat output.
• Before installation, make sure the boiler has not been damaged during handling and transport.
• Installation must be carried out by suitably qualified personnel, in accordance with current regulations.
• Disconnect the unit from the power supply before carrying out any cleaning or maintenance.
• FERROLI declines any liability for damage to persons and/or property due to incorrect installation, adjustment and maintenance, and
improper use.
• Startup of the boiler and related system must be carried out by authorized personnel.
• First startup is for checking that all the control and adjustment devices work properly.
• Long periods of non-use of the unit require the intervention of qualified personnel.
• The unit and its accessories must be disposed of appropriately, in conformity with the current regulations.
Regulations
The installer must ensure compliance with local and current regulations regarding: the place where the boiler is installed, the required
ventilation conditions; perfect tightness of the connection and flue; the fuel and electrical system connections, and any other provisions
regarding safety.
Warranty conditions
The validity of the warranty is subject to compliance with the rules and recommendations on use contained in this manual. Any non-
compliance or modification will void the warranty. The warranty does not cover damage due to corrosion from the acidic condensate of
combustion products or as a result of encrustations caused by the use of hard or aggressive water, such damage being attributable solely
to operation of the system.
2.
CERTIFICATIONS
The CE marking certifies that the products meet the essential requirements of the applicable directives.
The declaration of conformity may be requested from the manufacturer.
PRODUCT IDENTIFICATION CODES
TP3 COND 65
TP3 COND 100
TP3 COND 150
TP3 COND 230
TP3 COND 370
TP3 COND 500
TP3 COND 650
TP3 COND 820
TP3 COND 1000
COUNTRIES OF DESTINATION: IT
OIL / GAS
0RGZ3AXA
0RGZ4AXA
0RGZ5AXA
0RGZ8AXA
0RGZBAXA
0RGZDAXA
0RGZGAXA
0RGE01XA
0RGF02XA
cod. 30902850 - Rev 06 - 04-2022
49
EN
