Idiomas disponibles
Idiomas disponibles
1
Add gasoline stabilizer to the fuel tank, according to the manufacturer's
instructions, to reduce the degradation of gasoline.
2
Start the compressor and let the engine runs during 10 minutes, so that the
gasoline with the treatment flows through the admission circuit.
3
With a hand pump, pumps the gasoline for an approved fuel container.
NOTE: Do not use normal plastic bottles,
because some plastics decompose partially in
contact with gasoline and become it contaminated.
If reused, contaminated gasoline can damage an
engine.
DANGER:
Gasoline
flammable. During gasoline handling, never smoke
or cause any spark or flame.
4
Start the engine and let it stop for lack of fuel. This ensures that not the entire fuel
admission system is empty.
5
Replace the engine oil.
6
Remove the cap of spark plug (see chapter 10.3) and the spark plug. Put directly
into the cylinder (through the spark plug hole), a teaspoon of clean engine oil (10 ~
20ml). Smoothly, pull the starter rope of the engine, which will turn the engine and
distribute the oil. Then, put back the spark plug.
7
Slowly, pull the starter rope until you feel resistance. At this point, the piston is
rising in its compression stroke and the admission and exhaust valves are closed.
In this position, moisture cannot enter in the motor, which provides protection
against internal corrosion.
8
The compressor must be protected by its packaging or covered with a suitable
cloth, and stored in a stable, clean and dry place, free of moisture and without
direct sunlight.
is
explosive
and
66
