GENERGY CIERZO Instrucciones De Uso página 62

Idiomas disponibles

Idiomas disponibles

NOTE: The compressor should never work without the air filter, otherwise we will
have a quick engine wear.
WARNING: Do not use gasoline or solvents with a low flash point to clean the filter.
They are flammable and explosive under certain conditions.
10.3 Spark plug maintenance.
Recommended spark plugs: TORCH F6RTC, NGK BP7ES, BOSCH WR3C.
1
Remove the cap of spark plug, pulling it out.
2
With a spark plug wrench unscrew and remove the spark plug from the engine
(turn counterclockwise).
3
Visually check the spark plug. If the spark plug insulation is cracked or chipped,
replace it with a new one. To clean dirt on the electrode, use a very thin wire brush.
4
Check the electrode distance with a caliper. The distance should be between 0.6
and 0.7mm. If it does not match, adjust it carefully.
5
Carefully put back the spark plug, starting its threading manually to avoid the
damage of the thread. With the spark plug fully threaded make a final tightening with
a spark plug wrench, according to the following recommendations:
 New spark plugs: 1/2 turn.
 Used spark plugs: 1/8 to 1/4 turn.
6
Put back the cap of the spark plug and close the spark plug access cover with its
screw.
NOTE: The spark plug must be firmly tightened. An incorrectly fitted spark plug can
heat up and even damage the engine. On the other hand, over-tightening can damage the
spark plug and damage the thread of the cylinder head.
60
loading

Este manual también es adecuado para:

TramontanaMistral