Idiomas disponibles
Idiomas disponibles
7. Possible deffects
Before contacting the customer service department or vendor check the troubleshooting
table below.
Problem
Damaged lock of cutting
disks
Lid cannot be fixed properly.
Product is incorrectly cut
Cut product goes out of the
device with difficulty and is
not cut clean
The device is blocked
Microswitches on the
pusher lever and lid do not
work
The device cannot be
turned on
When malfunction cannot be removed:
-
do not open the housing,
contact the customer service department or vendor and give the following
-
information:
type of malfunction;
article number and serial number
(read from the rating plate on the back wall of the device).
Check if disks and disk fixing pin are clean.
Check if lid is positioned correctly and all its
elements are clean.
Check sharpness of blades of cutting disks.
Make sure that:
- the sweeper is installed with disks DT (whole
series) and DF1, DF2, DF3, DF4; DQ4;
- container is not full
- outlet hole is not clogged.
Make sure that:
- no deep frozen product is cut,
- cut product is not too hard,
- electric voltage conforms to the rating plate data.
Check if microswitches are not blocked by dirt or
other objects.
Check:
- if all protective elements (section 4.3) are
correctly fixed,
- if power supply cable is connected to the socket,
- if all switches on the device are turned on.
Solution
- 49 -
