Idiomas disponibles
Idiomas disponibles
5.2.3 Installation and replacement of cutting disks
WARNING! Injury hazard!
Blades of the cutting disks are very sharp! Always wear
solid, soft protective gloves allowing for firm grip of
objects during installation, replacement, and cleaning of
cutting disks.
For products to be grated select appropriate disks and install them in the device
before starting the grating process. Follow instructions for cut slices in section
4.1 "Technical data".
Lift the pusher lever as high as possible, loosen lid hinges, and remove lid with
oval filling hole.
Fig. 9 - Installation of
For DICING select appropriate pair of cutting disks (PS8 + DF8 / PS10 + DF10 /
PS14 + DF14).
Hint: While using two cutting disks at the same time
do not use the sweeper.
First install cutting disk PS... with notch to the right, then cutting disk DF..., rotating it
until it is firmly fixed (fig. 10).
Replace lid and lock it with hinges.
Put the sweeper on the shaft of the
cutting disk (fig. 9).
Then install selected cutting disk on the
shaft and rotate it until it is firmly fixed.
Replace lid and lock it with hinges.
sweeper
Fig. 10 - Installation of pair of cutting disks PS...-DF...
- 45 -
