Black+Decker BCAST90 Manual De Instrucciones página 12

English
• Remove any dirt and grass from the spool and housing.
• Unfasten the end of the cutting line and guide the line
into the eyelet Fig. K.
24
Fig. K
• Take the new spool and push it onto the boss
the housing (Fig. J). Rotate the spool slightly until it
is seated. The line should protrude approximately
5-3/8 inches (136 mm) from the housing.
• Align the tabs on the spool cap with the slots
housing (Fig. L).
• Push the cap onto the housing until it snaps securely
into place.
Fig. L

CAUTION:
the cutting line protrudes beyond the trimming blade,
cut it off so that it just reaches the blade.
Rewinding Spool From Bulk Line
(Fig. M–O)
(use only .065 in. ROUND diameter line)
Bulk line is also available for purchase from your local retailer.
nOTE: Hand wound spools from bulk line are likely to
become tangled more frequently than BLACK+DECKER
factory wound spools. For best results, factory wound spools
are recommended.
To Install Bulk Line, Follow the Steps Below
• Remove battery pack from trimmer.
• Remove the empty spool from the trimmer as described
in Replacing the Spool.
• Remove any remaining cutting line from the spool.
• Make a fold at the end of the cutting line at about
3/4 inch (19 mm) 27
the line anchoring slots
10
24
25
26
To avoid trimmer damage, if
. Feed the cutting line into one of
28 as shown in Fig. M.
Fig. M
• Insert the 3/4 inch (19 mm) end of the bulk line into
the hole
in Fig. N. Make sure the line is pulled tight against the
spool as shown in Fig. O.
Fig. N
in
in the
• Wind the cutting line onto the spool in the direction of
the arrow on the spool. Make sure to wind the line on
neatly and in layers. Do not crisscross (Fig. O).
• When the wound cutting line reaches the recesses
cut the line. (Fig. N).
• Fit the spool onto the trimmer as described in
Replacing the Spool.

CAUTION:
use the appropriate type of cutting line.
26
Fig. O
Troubleshooting
Trimmer Runs Slowly
1. Remove battery pack from trimmer.
2. Check that the spool housing can rotate freely. Carefully
clean it if necessary.
3. Check that the cutting line does not protrude more
than approximately 5-3/8 inches (136 mm) from the
spool. If it does, cut it off so that it just reaches the line
trimming blade.
Automatic Line Feed Does Not Work
1. Remove battery pack from trimmer.
2. Remove the spool cap.
28
in the spool adjacent to the slot as shown
29
30
Before you begin trimming, only
27
29
30 ,