Idiomas disponibles
Idiomas disponibles
CONNECTION THE WATER SUPPLIES AND
ELECTRICITY
Connecting the water inlet hose
1. Connect one end of the water inlet hose to
a cold water tap and tighten by hand (see
figure). Before performing the connection,
allow the water to run freely until it is
perfectly clear.
2. Connect the other end of the water inlet
hose to the water inlet valve on the rear of
the appliance and tighten by hand.
3. Turn on the tap slowly and make sure there
are no leaks.
• Do not twist, squash, modify or cut the
hose.
• Tighten the end of the hose firmly by hand.
• The supply water pressure must be in the
0.03—1.0MPa range. If the water pressure
exceeds this value, please fit a pressure
reducing valve.
• If the hose is not long enough, contact a
specialized
shop
technician.
• Never use second-hand water inlet hose.
• Use the new water inlet hose supplied with
the appliance.
or
an
authorized
CONNECTING THE DRAIN HOSE
Height of drain point
Height difference between the floor and
drainage point: min. 60cm(24 in.) and max.
100cm(39 in.).
TYPES OF DRAINAGE HOOKUPS
▪ Standpipe
Attach the drain hose to the elbow (no
supplied, available from our Customer Service
Department).
Position the elbow on the drain hose 4"
(100mm) from end of the hose as shown.
Insert this section of the drain hose into the
drain pipe, If the hose is pushed down too far,
this may cause the washer to self-syphon ie.
continuously empty as it is filling.
Secure the elbow and hose with a cable tie to
keep the hose from coming out of the drain
pipe during use.
98
